Commit 14e7dc76 authored by Ohad Ben-Cohen's avatar Ohad Ben-Cohen Committed by Chris Ball

mmc: quirks: wl1271 is MMC_QUIRK_DISABLE_CD

The wl12xx device supports disconnecting the pull-up resistor on
CD/DAT[3] (pin 1) of the card.

Tell SDIO core to disconnect that resistor during card init,
since we don't need it at that point (and anyway all
hosts shall provide pull-up resistors on all data lines DAT[3:0]
as described in section 6 of the SD physical specification).

As a result, this may save some power, but it's also generally healthy
since it prevents both ends from pulling up that pin, which
results in undesirable asymmetric physical bus.
Signed-off-by: default avatarOhad Ben-Cohen <ohad@wizery.com>
Signed-off-by: default avatarChris Ball <cjb@laptop.org>
parent 2059a02d
......@@ -66,6 +66,8 @@ static const struct mmc_fixup mmc_fixup_methods[] = {
remove_quirk, MMC_QUIRK_BROKEN_CLK_GATING },
{ SDIO_VENDOR_ID_TI, SDIO_DEVICE_ID_TI_WL1271,
add_quirk, MMC_QUIRK_NONSTD_FUNC_IF },
{ SDIO_VENDOR_ID_TI, SDIO_DEVICE_ID_TI_WL1271,
add_quirk, MMC_QUIRK_DISABLE_CD },
{ 0 }
};
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment