drm/i915: Fix audio power up sequence for gen10+ display

On platfroms with gen10+ display, driver must set the enable bit of
AUDIO_PIN_BUF_CTL register before transactions with the HDA controller
can proceed. Add setting this bit to the audio power up sequence.

Failing to do this resulted in errors during display audio codec probe,
and failures during resume from suspend.

Note: We may also need to disable the bit afterwards, but there are
still unresolved issues with that.

Bugzilla: https://bugs.freedesktop.org/show_bug.cgi?id=111214Signed-off-by: Kai Vehmanen <kai.vehmanen@linux.intel.com>
Signed-off-by: Jani Nikula <jani.nikula@intel.com>
Link: https://patchwork.freedesktop.org/patch/msgid/20191003085531.30990-1-kai.vehmanen@linux.intel.com

drivers/gpu/drm/i915/display/intel_audio.c

@@ -862,6 +862,11 @@ static unsigned long i915_audio_component_get_power(struct device *kdev)
 		/* Force CDCLK to 2*BCLK as long as we need audio powered. */
 		if (IS_CANNONLAKE(dev_priv) || IS_GEMINILAKE(dev_priv))
 			glk_force_audio_cdclk(dev_priv, true);
+
+		if (INTEL_GEN(dev_priv) >= 10 || IS_GEMINILAKE(dev_priv))
+			I915_WRITE(AUD_PIN_BUF_CTL,
+				   (I915_READ(AUD_PIN_BUF_CTL) |
+				    AUD_PIN_BUF_ENABLE));
 	}
 
 	return ret;

drivers/gpu/drm/i915/i915_reg.h

@@ -9133,6 +9133,8 @@ enum {
 #define   SKL_AUD_CODEC_WAKE_SIGNAL		(1 << 15)
 
 #define AUD_FREQ_CNTRL			_MMIO(0x65900)
+#define AUD_PIN_BUF_CTL		_MMIO(0x48414)
+#define   AUD_PIN_BUF_ENABLE		REG_BIT(31)
 
 /*
  * HSW - ICL power wells