drivers: net: xilinx_emaclite: remove arch limitation

The changes made in eccd5403 is enough for xilinx_emaclite to run
without problem on 64-bit systems. I have tested it on a Xilinx
FPGA with RV64 softcore. The architecture limitation in Kconfig
seems no longer necessary.

A small change is included to print address with %lx instead of
casting to int and print with %x.
Signed-off-by: Gary Guo <gary@garyguo.net>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/xilinx/Kconfig

@@ -18,7 +18,6 @@ if NET_VENDOR_XILINX
 
 config XILINX_EMACLITE
 	tristate "Xilinx 10/100 Ethernet Lite support"
-	depends on PPC32 || MICROBLAZE || ARCH_ZYNQ || MIPS || COMPILE_TEST
 	select PHYLIB
 	help
 	  This driver supports the 10/100 Ethernet Lite from Xilinx.

drivers/net/ethernet/xilinx/xilinx_emaclite.c

@@ -1193,8 +1193,8 @@ static int xemaclite_of_probe(struct platform_device *ofdev)
 	}
 
 	dev_info(dev,
-		 "Xilinx EmacLite at 0x%08X mapped to 0x%08lX, irq=%d\n",
-		 (unsigned int __force)ndev->mem_start,
+		 "Xilinx EmacLite at 0x%08lX mapped to 0x%08lX, irq=%d\n",
+		 (unsigned long __force)ndev->mem_start,
 		 (unsigned long __force)lp->base_addr, ndev->irq);
 	return 0;