SPI: add CSR SiRFprimaII SPI controller driver

CSR SiRFprimaII has two SPIs (SPI0 and SPI1). Features:
* Master and slave modes
* 8-/12-/16-/32-bit data unit
* 256 bytes receive data FIFO and 256 bytes transmit data FIFO
* Multi-unit frame
* Configurable SPI_EN (chip select pin) active state
* Configurable SPI_CLK polarity
* Configurable SPI_CLK phase
* Configurable MSB/LSB first
Signed-off-by: Zhiwu Song <zhiwu.song@csr.com>
Signed-off-by: Barry Song <Baohua.Song@csr.com>
Signed-off-by: Grant Likely <grant.likely@secretlab.ca>

drivers/spi/Kconfig

@@ -336,6 +336,13 @@ config SPI_SH_HSPI
 	help
 	  SPI driver for SuperH HSPI blocks.
 
+config SPI_SIRF
+	tristate "CSR SiRFprimaII SPI controller"
+	depends on ARCH_PRIMA2
+	select SPI_BITBANG
+	help
+	  SPI driver for CSR SiRFprimaII SoCs
+
 config SPI_STMP3XXX
 	tristate "Freescale STMP37xx/378x SPI/SSP controller"
 	depends on ARCH_STMP3XXX

drivers/spi/Makefile

@@ -53,6 +53,7 @@ obj-$(CONFIG_SPI_SH)			+= spi-sh.o
 obj-$(CONFIG_SPI_SH_HSPI)		+= spi-sh-hspi.o
 obj-$(CONFIG_SPI_SH_MSIOF)		+= spi-sh-msiof.o
 obj-$(CONFIG_SPI_SH_SCI)		+= spi-sh-sci.o
+obj-$(CONFIG_SPI_SIRF)		+= spi-sirf.o
 obj-$(CONFIG_SPI_STMP3XXX)		+= spi-stmp.o
 obj-$(CONFIG_SPI_TEGRA)			+= spi-tegra.o
 obj-$(CONFIG_SPI_TI_SSP)		+= spi-ti-ssp.o