mmc: sdhci-msm: Don't enable PWRSAVE_DLL for certain sdhc hosts

SDHC core with new 14lpp and later tech DLL should not enable
PWRSAVE_DLL since such controller's internal gating cannot meet
following MCLK requirement:
When MCLK is gated OFF, it is not gated for less than 0.5us and MCLK
must be switched on for at-least 1us before DATA starts coming.

Adding support for this requirement.
Signed-off-by: Ritesh Harjani <riteshh@codeaurora.org>
Signed-off-by: Veerabhadrarao Badiganti <vbadigan@codeaurora.org>
Reviewed-by: Can Guo <cang@codeaurora.org>
Acked-by: Adrian Hunter <adrian.hunter@intel.com>
Link: https://lore.kernel.org/r/1581077075-26011-1-git-send-email-vbadigan@codeaurora.orgSigned-off-by: Ulf Hansson <ulf.hansson@linaro.org>

drivers/mmc/host/sdhci-msm.c

@@ -977,9 +977,21 @@ static int sdhci_msm_cm_dll_sdc4_calibration(struct sdhci_host *host)
 		goto out;
 	}
 
-	config = readl_relaxed(host->ioaddr + msm_offset->core_vendor_spec3);
+	/*
+	 * Set CORE_PWRSAVE_DLL bit in CORE_VENDOR_SPEC3.
+	 * When MCLK is gated OFF, it is not gated for less than 0.5us
+	 * and MCLK must be switched on for at-least 1us before DATA
+	 * starts coming. Controllers with 14lpp and later tech DLL cannot
+	 * guarantee above requirement. So PWRSAVE_DLL should not be
+	 * turned on for host controllers using this DLL.
+	 */
+	if (!msm_host->use_14lpp_dll_reset) {
+		config = readl_relaxed(host->ioaddr +
+				msm_offset->core_vendor_spec3);
 		config |= CORE_PWRSAVE_DLL;
-	writel_relaxed(config, host->ioaddr + msm_offset->core_vendor_spec3);
+		writel_relaxed(config, host->ioaddr +
+				msm_offset->core_vendor_spec3);
+	}
 
 	/*
 	 * Drain writebuffer to ensure above DLL calibration