soundwire: qcom: gracefully handle too many ports in DT

There are two issues related to the number of ports coming from
Devicetree when exceeding in total QCOM_SDW_MAX_PORTS.  Both lead to
incorrect memory accesses:
1. With DTS having too big value of input or output ports, the driver,
   when copying port parameters from local/stack arrays into 'pconfig'
   array in 'struct qcom_swrm_ctrl', will iterate over their sizes.

2. If DTS also has too many parameters for these ports (e.g.
   qcom,ports-sinterval-low), the driver will overflow buffers on the
   stack when reading these properties from DTS.

Add a sanity check so incorrect DTS will not cause kernel memory
corruption.
Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
Reviewed-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
Reviewed-by: Konrad Dybcio <konrad.dybcio@linaro.org>
Link: https://lore.kernel.org/r/20230222144412.237832-2-krzysztof.kozlowski@linaro.orgSigned-off-by: Vinod Koul <vkoul@kernel.org>

drivers/soundwire/qcom.c

@@ -1218,6 +1218,9 @@ static int qcom_swrm_get_port_config(struct qcom_swrm_ctrl *ctrl)
 	ctrl->num_dout_ports = val;
 
 	nports = ctrl->num_dout_ports + ctrl->num_din_ports;
+	if (nports > QCOM_SDW_MAX_PORTS)
+		return -EINVAL;
+
 	/* Valid port numbers are from 1-14, so mask out port 0 explicitly */
 	set_bit(0, &ctrl->dout_port_mask);
 	set_bit(0, &ctrl->din_port_mask);