ARM: at91: prepare sam9 dt boards transition to common clk

This patch prepare the transition to common clk for sam9 dt boards by
replacing the timer init callback.

Clocks registration cannot be done in early init callback (as formerly done
by the old clk implementation) because it requires dynamic allocation
which is not ready yet during early init.

In the other hand, at91 clocks must be registered before
at91sam926x_pit_init is called because PIT (Periodic Interval Timer) driver
request the master clk (mck).

A new function (at91sam9_dt_timer_init) is created to fullfil these needs.
This function registers all at91 clks using the dt definition before
calling the PIT init function.
The device tree clock registration is enabled only if common clk is
selected. Else the old clk registration is been done during
at91_dt_initialize call.
Signed-off-by: Boris BREZILLON <b.brezillon@overkiz.com>
Signed-off-by: Alexandre Belloni <alexandre.belloni@free-electrons.com>
Signed-off-by: Nicolas Ferre <nicolas.ferre@atmel.com>

arch/arm/mach-at91/board-dt-sam9.c

@@ -13,6 +13,7 @@
 #include <linux/gpio.h>
 #include <linux/of.h>
 #include <linux/of_irq.h>
+#include <linux/clk-provider.h>
 
 #include <asm/setup.h>
 #include <asm/irq.h>
@@ -25,6 +26,14 @@
 #include "generic.h"
 
 
+static void __init sam9_dt_timer_init(void)
+{
+#if defined(CONFIG_COMMON_CLK)
+	of_clk_init(NULL);
+#endif
+	at91sam926x_pit_init();
+}
+
 static const struct of_device_id irq_of_match[] __initconst = {
 
 	{ .compatible = "atmel,at91rm9200-aic", .data = at91_aic_of_init },
@@ -43,7 +52,7 @@ static const char *at91_dt_board_compat[] __initdata = {
 
 DT_MACHINE_START(at91sam_dt, "Atmel AT91SAM (Device Tree)")
 	/* Maintainer: Atmel */
-	.init_time	= at91sam926x_pit_init,
+	.init_time	= sam9_dt_timer_init,
 	.map_io		= at91_map_io,
 	.handle_irq	= at91_aic_handle_irq,
 	.init_early	= at91_dt_initialize,