gpio: tegra186: remove unneeded loop in tegra186_gpio_init_route_mapping()

Reviewing the j loop over num_irqs_per_bank, in the code previous
to the fixes: commit, every j was used. now only when j == 0.
If only j == 0 is used, there is no need for the loop.

Fixes: 21038680 ("gpio: tegra186: Support multiple interrupts per bank")
Signed-off-by: Tom Rix <trix@redhat.com>
Acked-by: Thierry Reding <treding@nvidia.com>
Signed-off-by: Bartosz Golaszewski <bartosz.golaszewski@linaro.org>

drivers/gpio/gpio-tegra186.c

@@ -677,7 +677,7 @@ static const struct of_device_id tegra186_pmc_of_match[] = {
 static void tegra186_gpio_init_route_mapping(struct tegra_gpio *gpio)
 {
 	struct device *dev = gpio->gpio.parent;
-	unsigned int i, j;
+	unsigned int i;
 	u32 value;
 
 	for (i = 0; i < gpio->soc->num_ports; i++) {
@@ -699,11 +699,10 @@ static void tegra186_gpio_init_route_mapping(struct tegra_gpio *gpio)
 			 * On Tegra194 and later, each pin can be routed to one or more
 			 * interrupts.
 			 */
-			for (j = 0; j < gpio->num_irqs_per_bank; j++) {
 			dev_dbg(dev, "programming default interrupt routing for port %s\n",
 				port->name);
 
-				offset = TEGRA186_GPIO_INT_ROUTE_MAPPING(p, j);
+			offset = TEGRA186_GPIO_INT_ROUTE_MAPPING(p, 0);
 
 			/*
 			 * By default we only want to route GPIO pins to IRQ 0. This works
@@ -714,14 +713,11 @@ static void tegra186_gpio_init_route_mapping(struct tegra_gpio *gpio)
 			 * to configure the interrupt routing and pass only the valid
 			 * interrupts via device tree.
 			 */
-				if (j == 0) {
 			value = readl(base + offset);
 			value = BIT(port->pins) - 1;
 			writel(value, base + offset);
 		}
 	}
-		}
-	}
 }
 
 static unsigned int tegra186_gpio_irqs_per_bank(struct tegra_gpio *gpio)