geneve: add transport ports in route lookup for geneve
This patch adds transport ports information for route lookup so that IPsec can select Geneve tunnel traffic to do encryption. This is needed for OVS/OVN IPsec with encrypted Geneve tunnels. This can be tested by configuring a host-host VPN using an IKE daemon and specifying port numbers. For example, for an Openswan-type configuration, the following parameters should be configured on both hosts and IPsec set up as-per normal: $ cat /etc/ipsec.conf conn in ... left=$IP1 right=$IP2 ... leftprotoport=udp/6081 rightprotoport=udp ... conn out ... left=$IP1 right=$IP2 ... leftprotoport=udp rightprotoport=udp/6081 ... The tunnel can then be setup using "ip" on both hosts (but changing the relevant IP addresses): $ ip link add tun type geneve id 1000 remote $IP2 $ ip addr add 192.168.0.1/24 dev tun $ ip link set tun up This can then be tested by pinging from $IP1: $ ping 192.168.0.2 Without this patch the traffic is unencrypted on the wire. Fixes: 2d07dc79 ("geneve: add initial netdev driver for GENEVE tunnels") Signed-off-by: Qiuyu Xiao <qiuyu.xiao.qyx@gmail.com> Signed-off-by: Mark Gray <mark.d.gray@redhat.com> Reviewed-by: Greg Rose <gvrose8192@gmail.com> Signed-off-by: David S. Miller <davem@davemloft.net>
Showing
Please register or sign in to comment