mm/s390: use general page fault accounting

Use the general page fault accounting by passing regs into
handle_mm_fault().  It naturally solve the issue of multiple page fault
accounting when page fault retry happened.
Signed-off-by: Peter Xu <peterx@redhat.com>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Reviewed-by: Gerald Schaefer <gerald.schaefer@de.ibm.com>
Acked-by: Gerald Schaefer <gerald.schaefer@de.ibm.com>
Cc: Alexander Gordeev <agordeev@linux.ibm.com>
Cc: Heiko Carstens <heiko.carstens@de.ibm.com>
Cc: Vasily Gorbik <gor@linux.ibm.com>
Cc: Christian Borntraeger <borntraeger@de.ibm.com>
Link: http://lkml.kernel.org/r/20200707225021.200906-19-peterx@redhat.comSigned-off-by: Linus Torvalds <torvalds@linux-foundation.org>

arch/s390/mm/fault.c

@@ -476,7 +476,7 @@ static inline vm_fault_t do_exception(struct pt_regs *regs, int access)
 	 * make sure we exit gracefully rather than endlessly redo
 	 * the fault.
 	 */
-	fault = handle_mm_fault(vma, address, flags, NULL);
+	fault = handle_mm_fault(vma, address, flags, regs);
 	if (fault_signal_pending(fault, regs)) {
 		fault = VM_FAULT_SIGNAL;
 		if (flags & FAULT_FLAG_RETRY_NOWAIT)
@@ -486,21 +486,7 @@ static inline vm_fault_t do_exception(struct pt_regs *regs, int access)
 	if (unlikely(fault & VM_FAULT_ERROR))
 		goto out_up;
 
-	/*
-	 * Major/minor page fault accounting is only done on the
-	 * initial attempt. If we go through a retry, it is extremely
-	 * likely that the page will be found in page cache at that point.
-	 */
 	if (flags & FAULT_FLAG_ALLOW_RETRY) {
-		if (fault & VM_FAULT_MAJOR) {
-			tsk->maj_flt++;
-			perf_sw_event(PERF_COUNT_SW_PAGE_FAULTS_MAJ, 1,
-				      regs, address);
-		} else {
-			tsk->min_flt++;
-			perf_sw_event(PERF_COUNT_SW_PAGE_FAULTS_MIN, 1,
-				      regs, address);
-		}
 		if (fault & VM_FAULT_RETRY) {
 			if (IS_ENABLED(CONFIG_PGSTE) && gmap &&
 			    (flags & FAULT_FLAG_RETRY_NOWAIT)) {