tty: serial: msm: Add TX DMA support

Add transmit DMA support for UARTDM type of controllers.

Tested on APQ8064, which have UARTDM v1.3 and ADM DMA engine
and APQ8016, which have UARTDM v1.4 and BAM DMA engine.
Signed-off-by: Ivan T. Ivanov <ivan.ivanov@linaro.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

Documentation/devicetree/bindings/serial/qcom,msm-uartdm.txt

@@ -26,6 +26,9 @@ Required properties:
 Optional properties:
 - dmas: Should contain dma specifiers for transmit and receive channels
 - dma-names: Should contain "tx" for transmit and "rx" for receive channels
+- qcom,tx-crci: Identificator <u32> for Client Rate Control Interface to be
+           used with TX DMA channel. Required when using DMA for transmission
+           with UARTDM v1.3 and bellow.
 
 Note: Aliases may be defined to ensure the correct ordering of the UARTs.
 The alias serialN will result in the UART being assigned port N.  If any

drivers/tty/serial/msm_serial.h

@@ -121,6 +121,9 @@
 #define UARTDM_DMEN_RX_SC_ENABLE BIT(5)
 #define UARTDM_DMEN_TX_SC_ENABLE BIT(4)
 
+#define UARTDM_DMEN_TX_BAM_ENABLE BIT(2)	/* UARTDM_1P4 */
+#define UARTDM_DMEN_TX_DM_ENABLE  BIT(0)	/* < UARTDM_1P4 */
+
 #define UARTDM_DMRX		0x34
 #define UARTDM_NCF_TX		0x40
 #define UARTDM_RX_TOTAL_SNAP	0x38