Merge branch 'for-2637/i2c-all' of git://git.fluff.org/bjdooks/linux

* 'for-2637/i2c-all' of git://git.fluff.org/bjdooks/linux:
  i2c-intel-mid: Driver depends on PCI
  i2c-intel-mid: support for Moorestown and Medfield platform
  i2c-nomadik: fixup bus delays
  i2c-nomadik: support smbus emulation
  i2c-nomadik: dynamic clocking
  i2c-nomadik: documentation fixes
  i2c-s3c2410: Enable i2c clock only when doing some transfert

drivers/i2c/busses/Kconfig

@@ -396,6 +396,16 @@ config I2C_IMX
 	  This driver can also be built as a module.  If so, the module
 	  will be called i2c-imx.
 
+config I2C_INTEL_MID
+	tristate "Intel Moorestown/Medfield Platform I2C controller"
+	depends on PCI
+	help
+	  Say Y here if you have an Intel Moorestown/Medfield platform I2C
+	  controller.
+
+	  This support is also available as a module. If so, the module
+	  will be called i2c-intel-mid.
+
 config I2C_IOP3XX
 	tristate "Intel IOPx3xx and IXP4xx on-chip I2C interface"
 	depends on ARCH_IOP32X || ARCH_IOP33X || ARCH_IXP4XX || ARCH_IOP13XX

drivers/i2c/busses/Makefile

@@ -38,6 +38,7 @@ obj-$(CONFIG_I2C_GPIO)		+= i2c-gpio.o
 obj-$(CONFIG_I2C_HIGHLANDER)	+= i2c-highlander.o
 obj-$(CONFIG_I2C_IBM_IIC)	+= i2c-ibm_iic.o
 obj-$(CONFIG_I2C_IMX)		+= i2c-imx.o
+obj-$(CONFIG_I2C_INTEL_MID)	+= i2c-intel-mid.o
 obj-$(CONFIG_I2C_IOP3XX)	+= i2c-iop3xx.o
 obj-$(CONFIG_I2C_IXP2000)	+= i2c-ixp2000.o
 obj-$(CONFIG_I2C_MPC)		+= i2c-mpc.o

drivers/i2c/busses/i2c-nomadik.c

 /*
- * Copyright (C) 2009 ST-Ericsson
+ * Copyright (C) 2009 ST-Ericsson SA
  * Copyright (C) 2009 STMicroelectronics
  *
  * I2C master mode controller driver, used in Nomadik 8815
@@ -103,6 +103,9 @@
 /* maximum threshold value */
 #define MAX_I2C_FIFO_THRESHOLD	15
 
+/* per-transfer delay, required for the hardware to stabilize */
+#define I2C_DELAY		150
+
 enum i2c_status {
 	I2C_NOP,
 	I2C_ON_GOING,
@@ -118,7 +121,7 @@ enum i2c_operation {
 };
 
 /* controller response timeout in ms */
-#define I2C_TIMEOUT_MS	500
+#define I2C_TIMEOUT_MS	2000
 
 /**
  * struct i2c_nmk_client - client specific data
@@ -250,6 +253,8 @@ static int init_hw(struct nmk_i2c_dev *dev)
 {
 	int stat;
 
+	clk_enable(dev->clk);
+
 	stat = flush_i2c_fifo(dev);
 	if (stat)
 		return stat;
@@ -263,6 +268,9 @@ static int init_hw(struct nmk_i2c_dev *dev)
 
 	dev->cli.operation = I2C_NO_OPERATION;
 
+	clk_disable(dev->clk);
+
+	udelay(I2C_DELAY);
 	return 0;
 }
 
@@ -431,7 +439,6 @@ static int read_i2c(struct nmk_i2c_dev *dev)
 		(void) init_hw(dev);
 		status = -ETIMEDOUT;
 	}
-
 	return status;
 }
 
@@ -502,9 +509,9 @@ static int write_i2c(struct nmk_i2c_dev *dev)
 
 /**
  * nmk_i2c_xfer() - I2C transfer function used by kernel framework
- * @i2c_adap 	- Adapter pointer to the controller
- * @msgs[] - Pointer to data to be written.
- * @num_msgs - Number of messages to be executed
+ * @i2c_adap: Adapter pointer to the controller
+ * @msgs: Pointer to data to be written.
+ * @num_msgs: Number of messages to be executed
  *
  * This is the function called by the generic kernel i2c_transfer()
  * or i2c_smbus...() API calls. Note that this code is protected by the
@@ -559,6 +566,8 @@ static int nmk_i2c_xfer(struct i2c_adapter *i2c_adap,
 	if (status)
 		return status;
 
+	clk_enable(dev->clk);
+
 	/* setup the i2c controller */
 	setup_i2c_controller(dev);
 
@@ -591,10 +600,13 @@ static int nmk_i2c_xfer(struct i2c_adapter *i2c_adap,
 			dev_err(&dev->pdev->dev, "%s\n",
 				cause >= ARRAY_SIZE(abort_causes)
 				? "unknown reason" : abort_causes[cause]);
+			clk_disable(dev->clk);
 			return status;
 		}
-		mdelay(1);
+		udelay(I2C_DELAY);
 	}
+	clk_disable(dev->clk);
+
 	/* return the no. messages processed */
 	if (status)
 		return status;
@@ -605,6 +617,7 @@ static int nmk_i2c_xfer(struct i2c_adapter *i2c_adap,
 /**
  * disable_interrupts() - disable the interrupts
  * @dev: private data of controller
+ * @irq: interrupt number
  */
 static int disable_interrupts(struct nmk_i2c_dev *dev, u32 irq)
 {
@@ -794,10 +807,7 @@ static irqreturn_t i2c_irq_handler(int irq, void *arg)
 
 static unsigned int nmk_i2c_functionality(struct i2c_adapter *adap)
 {
-	return I2C_FUNC_I2C
-		| I2C_FUNC_SMBUS_BYTE_DATA
-		| I2C_FUNC_SMBUS_WORD_DATA
-		| I2C_FUNC_SMBUS_I2C_BLOCK;
+	return I2C_FUNC_I2C | I2C_FUNC_SMBUS_EMUL;
 }
 
 static const struct i2c_algorithm nmk_i2c_algo = {
@@ -857,8 +867,6 @@ static int __devinit nmk_i2c_probe(struct platform_device *pdev)
 		goto err_no_clk;
 	}
 
-	clk_enable(dev->clk);
-
 	adap = &dev->adap;
 	adap->dev.parent = &pdev->dev;
 	adap->owner	= THIS_MODULE;
@@ -895,7 +903,6 @@ static int __devinit nmk_i2c_probe(struct platform_device *pdev)
 	return 0;
 
  err_init_hw:
-	clk_disable(dev->clk);
  err_add_adap:
 	clk_put(dev->clk);
  err_no_clk:
@@ -928,7 +935,6 @@ static int __devexit nmk_i2c_remove(struct platform_device *pdev)
 	iounmap(dev->virtbase);
 	if (res)
 		release_mem_region(res->start, resource_size(res));
-	clk_disable(dev->clk);
 	clk_put(dev->clk);
 	platform_set_drvdata(pdev, NULL);
 	kfree(dev);

drivers/i2c/busses/i2c-s3c2410.c

@@ -554,18 +554,23 @@ static int s3c24xx_i2c_xfer(struct i2c_adapter *adap,
 	int retry;
 	int ret;
 
+	clk_enable(i2c->clk);
+
 	for (retry = 0; retry < adap->retries; retry++) {
 
 		ret = s3c24xx_i2c_doxfer(i2c, msgs, num);
 
-		if (ret != -EAGAIN)
+		if (ret != -EAGAIN) {
+			clk_disable(i2c->clk);
 			return ret;
+		}
 
 		dev_dbg(i2c->dev, "Retrying transmission (%d)\n", retry);
 
 		udelay(100);
 	}
 
+	clk_disable(i2c->clk);
 	return -EREMOTEIO;
 }
 
@@ -910,6 +915,7 @@ static int s3c24xx_i2c_probe(struct platform_device *pdev)
 	platform_set_drvdata(pdev, i2c);
 
 	dev_info(&pdev->dev, "%s: S3C I2C adapter\n", dev_name(&i2c->adap.dev));
+	clk_disable(i2c->clk);
 	return 0;
 
  err_cpufreq:
@@ -977,7 +983,9 @@ static int s3c24xx_i2c_resume(struct device *dev)
 	struct s3c24xx_i2c *i2c = platform_get_drvdata(pdev);
 
 	i2c->suspended = 0;
+	clk_enable(i2c->clk);
 	s3c24xx_i2c_init(i2c);
+	clk_disable(i2c->clk);
 
 	return 0;
 }