Merge branch 'marvel10g-suspend-resume'

Antoine Tenart says:

====================
net: phy: marvell10g: implement suspend/resume callbacks

This series implements the suspend/resume callbacks in the marvell10g
PHY driver.

Thanks,
Antoine

Since v3:
  - Use the new phy_set/clear_bits_mmd() instead of phy_modify_mmd().
  - Use VEND2.f001.11 to power down the port instead of the per-mode
    LPOWER.

Since v2:
  - Removed the third patch, setting the PHY in low power by default, as
    the change was controversial.
  - Rebased on the latest net-next.

Since v1:
  - Fixed a mix up in the patches where two implementations of the
    suspend/resume callbacks were kept in the driver.
  - Rebased on the latest net-next.
====================
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/phy/marvell10g.c

@@ -48,6 +48,8 @@ enum {
 	MV_AN_STAT1000		= 0x8001, /* 1000base-T status register */
 
 	/* Vendor2 MMD registers */
+	MV_V2_PORT_CTRL		= 0xf001,
+	MV_V2_PORT_CTRL_PWRDOWN = 0x0800,
 	MV_V2_TEMP_CTRL		= 0xf08a,
 	MV_V2_TEMP_CTRL_MASK	= 0xc000,
 	MV_V2_TEMP_CTRL_SAMPLE	= 0x0000,
@@ -226,11 +228,19 @@ static int mv3310_probe(struct phy_device *phydev)
 
 static int mv3310_suspend(struct phy_device *phydev)
 {
-	return 0;
+	return phy_set_bits_mmd(phydev, MDIO_MMD_VEND2, MV_V2_PORT_CTRL,
+				MV_V2_PORT_CTRL_PWRDOWN);
 }
 
 static int mv3310_resume(struct phy_device *phydev)
 {
+	int ret;
+
+	ret = phy_clear_bits_mmd(phydev, MDIO_MMD_VEND2, MV_V2_PORT_CTRL,
+				 MV_V2_PORT_CTRL_PWRDOWN);
+	if (ret)
+		return ret;
+
 	return mv3310_hwmon_config(phydev, true);
 }
 
@@ -474,6 +484,8 @@ static struct phy_driver mv3310_drivers[] = {
 		.name		= "mv88x2110",
 		.get_features	= genphy_c45_pma_read_abilities,
 		.probe		= mv3310_probe,
+		.suspend	= mv3310_suspend,
+		.resume		= mv3310_resume,
 		.soft_reset	= genphy_no_soft_reset,
 		.config_init	= mv3310_config_init,
 		.config_aneg	= mv3310_config_aneg,