staging: dpaa2-ethsw: setup the STP state for all installed VLANs

Setup the STP state for all VLANs installed on the port. This is also
avoiding the error situation when the DEFAULT_VLAN_ID is not installed
on the port (thus the firmware complains that it cannot setup the
required STP state).
Signed-off-by: Ioana Ciornei <ioana.ciornei@nxp.com>
Link: https://lore.kernel.org/r/20200721091919.20394-4-ioana.ciornei@nxp.comSigned-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

drivers/staging/fsl-dpaa2/ethsw/ethsw.c

@@ -183,14 +183,17 @@ static int ethsw_port_set_flood(struct ethsw_port_priv *port_priv, bool enable)
 static int ethsw_port_set_stp_state(struct ethsw_port_priv *port_priv, u8 state)
 {
 	struct dpsw_stp_cfg stp_cfg = {
-		.vlan_id = DEFAULT_VLAN_ID,
 		.state = state,
 	};
 	int err;
+	u16 vid;
 
 	if (!netif_running(port_priv->netdev) || state == port_priv->stp_state)
 		return 0;	/* Nothing to do */
 
+	for (vid = 0; vid <= VLAN_VID_MASK; vid++) {
+		if (port_priv->vlans[vid] & ETHSW_VLAN_MEMBER) {
+			stp_cfg.vlan_id = vid;
 			err = dpsw_if_set_stp(port_priv->ethsw_data->mc_io, 0,
 					      port_priv->ethsw_data->dpsw_handle,
 					      port_priv->idx, &stp_cfg);
@@ -199,6 +202,8 @@ static int ethsw_port_set_stp_state(struct ethsw_port_priv *port_priv, u8 state)
 					   "dpsw_if_set_stp err %d\n", err);
 				return err;
 			}
+		}
+	}
 
 	port_priv->stp_state = state;