PCI: Work around Intel I210 ROM BAR overlap defect

Per PCIe r5, sec 7.5.1.2.4, a device must not claim accesses to its
Expansion ROM unless both the Memory Space Enable and the Expansion ROM
Enable bit are set.  But apparently some Intel I210 NICs don't work
correctly if the ROM BAR overlaps another BAR, even if the Expansion ROM is
disabled.

Michael reported that on a Kontron SMARC-sAL28 ARM64 system with U-Boot
v2021.01-rc3, the ROM BAR overlaps BAR 3, and networking doesn't work at
all:

  BAR 0: 0x40000000 (32-bit, non-prefetchable) [size=1M]
  BAR 3: 0x40200000 (32-bit, non-prefetchable) [size=16K]
  ROM:   0x40200000 (disabled) [size=1M]

  NETDEV WATCHDOG: enP2p1s0 (igb): transmit queue 0 timed out
  Hardware name: Kontron SMARC-sAL28 (Single PHY) on SMARC Eval 2.0 carrier (DT)
  igb 0002:01:00.0 enP2p1s0: Reset adapter

Previously, pci_std_update_resource() wrote the assigned ROM address to the
BAR only when the ROM was enabled.  This meant that the I210 ROM BAR could
be left with an address assigned by firmware, which might overlap with
other BARs.

Quirk these I210 devices so pci_std_update_resource() always writes the
assigned address to the ROM BAR, whether or not the ROM is enabled.

Link: https://lore.kernel.org/r/20211223163754.GA1267351@bhelgaas
Link: https://lore.kernel.org/r/20201230185317.30915-1-michael@walle.cc
Link: https://bugzilla.kernel.org/show_bug.cgi?id=211105Reported-by: Michael Walle <michael@walle.cc>
Tested-by: Michael Walle <michael@walle.cc>
Signed-off-by: Bjorn Helgaas <bhelgaas@google.com>

drivers/pci/quirks.c

@@ -5857,3 +5857,13 @@ static void nvidia_ion_ahci_fixup(struct pci_dev *pdev)
 	pdev->dev_flags |= PCI_DEV_FLAGS_HAS_MSI_MASKING;
 }
 DECLARE_PCI_FIXUP_FINAL(PCI_VENDOR_ID_NVIDIA, 0x0ab8, nvidia_ion_ahci_fixup);
+
+static void rom_bar_overlap_defect(struct pci_dev *dev)
+{
+	pci_info(dev, "working around ROM BAR overlap defect\n");
+	dev->rom_bar_overlap = 1;
+}
+DECLARE_PCI_FIXUP_EARLY(PCI_VENDOR_ID_INTEL, 0x1533, rom_bar_overlap_defect);
+DECLARE_PCI_FIXUP_EARLY(PCI_VENDOR_ID_INTEL, 0x1536, rom_bar_overlap_defect);
+DECLARE_PCI_FIXUP_EARLY(PCI_VENDOR_ID_INTEL, 0x1537, rom_bar_overlap_defect);
+DECLARE_PCI_FIXUP_EARLY(PCI_VENDOR_ID_INTEL, 0x1538, rom_bar_overlap_defect);

drivers/pci/setup-res.c

@@ -75,11 +75,15 @@ static void pci_std_update_resource(struct pci_dev *dev, int resno)
 		 * as zero when disabled, so don't update ROM BARs unless
 		 * they're enabled.  See
 		 * https://lore.kernel.org/r/43147B3D.1030309@vc.cvut.cz/
+		 * But we must update ROM BAR for buggy devices where even a
+		 * disabled ROM can conflict with other BARs.
 		 */
-		if (!(res->flags & IORESOURCE_ROM_ENABLE))
+		if (!(res->flags & IORESOURCE_ROM_ENABLE) &&
+		    !dev->rom_bar_overlap)
 			return;
 
 		reg = dev->rom_base_reg;
+		if (res->flags & IORESOURCE_ROM_ENABLE)
 			new |= PCI_ROM_ADDRESS_ENABLE;
 	} else
 		return;

include/linux/pci.h

@@ -455,6 +455,7 @@ struct pci_dev {
 	unsigned int	link_active_reporting:1;/* Device capable of reporting link active */
 	unsigned int	no_vf_scan:1;		/* Don't scan for VFs after IOV enablement */
 	unsigned int	no_command_memory:1;	/* No PCI_COMMAND_MEMORY */
+	unsigned int	rom_bar_overlap:1;	/* ROM BAR disable broken */
 	pci_dev_flags_t dev_flags;
 	atomic_t	enable_cnt;	/* pci_enable_device has been called */