KVM: VMX: Fix VPID capability detection

In my setup, EPT is not exposed to L1, the VPID capability is exposed and
can be observed by vmxcap tool in L1:
INVVPID supported                        yes
Individual-address INVVPID               yes
Single-context INVVPID                   yes
All-context INVVPID                      yes
Single-context-retaining-globals INVVPID yes

However, the module parameter of VPID observed in L1 is always N, the
cpu_has_vmx_invvpid() check in L1 KVM fails since vmx_capability.vpid
is 0 and it is not read from MSR due to EPT is not exposed.

The VPID can be used to tag linear mappings when EPT is not enabled. However,
current logic just detects VPID capability if EPT is enabled, this patch
fixes it.

Cc: Paolo Bonzini <pbonzini@redhat.com>
Cc: Radim Krčmář <rkrcmar@redhat.com>
Cc: Jim Mattson <jmattson@google.com>
Signed-off-by: Wanpeng Li <wanpeng.li@hotmail.com>
Signed-off-by: Radim Krčmář <rkrcmar@redhat.com>

arch/x86/kvm/vmx.c

@@ -3681,14 +3681,25 @@ static __init int setup_vmcs_config(struct vmcs_config *vmcs_conf)
 				SECONDARY_EXEC_VIRTUALIZE_X2APIC_MODE |
 				SECONDARY_EXEC_VIRTUAL_INTR_DELIVERY);
 
+	rdmsr_safe(MSR_IA32_VMX_EPT_VPID_CAP,
+		&vmx_capability.ept, &vmx_capability.vpid);
+
 	if (_cpu_based_2nd_exec_control & SECONDARY_EXEC_ENABLE_EPT) {
 		/* CR3 accesses and invlpg don't need to cause VM Exits when EPT
 		   enabled */
 		_cpu_based_exec_control &= ~(CPU_BASED_CR3_LOAD_EXITING |
 					     CPU_BASED_CR3_STORE_EXITING |
 					     CPU_BASED_INVLPG_EXITING);
-		rdmsr(MSR_IA32_VMX_EPT_VPID_CAP,
-		      vmx_capability.ept, vmx_capability.vpid);
+	} else if (vmx_capability.ept) {
+		vmx_capability.ept = 0;
+		pr_warn_once("EPT CAP should not exist if not support "
+				"1-setting enable EPT VM-execution control\n");
+	}
+	if (!(_cpu_based_2nd_exec_control & SECONDARY_EXEC_ENABLE_VPID) &&
+		vmx_capability.vpid) {
+		vmx_capability.vpid = 0;
+		pr_warn_once("VPID CAP should not exist if not support "
+				"1-setting enable VPID VM-execution control\n");
 	}
 
 	min = VM_EXIT_SAVE_DEBUG_CONTROLS | VM_EXIT_ACK_INTR_ON_EXIT;