Commit 624f8e50 authored by Matt Carlson's avatar Matt Carlson Committed by David S. Miller

tg3: Allow screaming interrupt detection

The tg3 driver's ISR is coded to accept interrupts as its own if the
status block tag does not equal the last tag the driver has seen.  The
last_tag field is updated from tg3_poll.  In a screaming interrupt
situation from another device sharing tg3's IRQ, tg3_poll does not get
a chance to be called, so the last_tag will always be out of sync with
the status block tag.  Consequently, the driver will continually
declare the screaming interrupts as its own, thus thwarting the
screaming interrupt detection logic.

This patch solves the problem by creating a new last_irq_tag member and
recording the status block tag in the ISR.  The ISR then checks the
last_irq_tag for interrupt ownership.

Many thanks to John Marvin for the detailed bug report and analysis and
Michael Chan for the bugfix.
Signed-off-by: default avatarMatt Carlson <mcarlson@broadcom.com>
Signed-off-by: default avatarMichael Chan <mchan@broadcom.com>
Tested-by: default avatarJohn Marvin <jsm@fc.hp.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent e5e9743b
......@@ -4656,6 +4656,7 @@ static int tg3_poll(struct napi_struct *napi, int budget)
* so we must read it before checking for more work.
*/
tp->last_tag = sblk->status_tag;
tp->last_irq_tag = tp->last_tag;
rmb();
} else
sblk->status &= ~SD_STATUS_UPDATED;
......@@ -4811,7 +4812,7 @@ static irqreturn_t tg3_interrupt_tagged(int irq, void *dev_id)
* Reading the PCI State register will confirm whether the
* interrupt is ours and will flush the status block.
*/
if (unlikely(sblk->status_tag == tp->last_tag)) {
if (unlikely(sblk->status_tag == tp->last_irq_tag)) {
if ((tp->tg3_flags & TG3_FLAG_CHIP_RESETTING) ||
(tr32(TG3PCI_PCISTATE) & PCISTATE_INT_NOT_ACTIVE)) {
handled = 0;
......@@ -4831,18 +4832,22 @@ static irqreturn_t tg3_interrupt_tagged(int irq, void *dev_id)
* excessive spurious interrupts can be worse in some cases.
*/
tw32_mailbox_f(MAILBOX_INTERRUPT_0 + TG3_64BIT_REG_LOW, 0x00000001);
/*
* In a shared interrupt configuration, sometimes other devices'
* interrupts will scream. We record the current status tag here
* so that the above check can report that the screaming interrupts
* are unhandled. Eventually they will be silenced.
*/
tp->last_irq_tag = sblk->status_tag;
if (tg3_irq_sync(tp))
goto out;
if (napi_schedule_prep(&tp->napi)) {
prefetch(&tp->rx_rcb[tp->rx_rcb_ptr]);
/* Update last_tag to mark that this status has been
* seen. Because interrupt may be shared, we may be
* racing with tg3_poll(), so only update last_tag
* if tg3_poll() is not scheduled.
*/
tp->last_tag = sblk->status_tag;
__napi_schedule(&tp->napi);
}
napi_schedule(&tp->napi);
out:
return IRQ_RETVAL(handled);
}
......@@ -6156,6 +6161,7 @@ static int tg3_chip_reset(struct tg3 *tp)
tp->hw_status->status_tag = 0;
}
tp->last_tag = 0;
tp->last_irq_tag = 0;
smp_mb();
synchronize_irq(tp->pdev->irq);
......@@ -7138,7 +7144,6 @@ static int tg3_reset_hw(struct tg3 *tp, int reset_phy)
udelay(100);
tw32_mailbox_f(MAILBOX_INTERRUPT_0 + TG3_64BIT_REG_LOW, 0);
tp->last_tag = 0;
if (!(tp->tg3_flags2 & TG3_FLG2_5705_PLUS)) {
tw32_f(DMAC_MODE, DMAC_MODE_ENABLE);
......
......@@ -2501,6 +2501,7 @@ struct tg3 {
struct tg3_hw_status *hw_status;
dma_addr_t status_mapping;
u32 last_tag;
u32 last_irq_tag;
u32 msg_enable;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment