wifi: mac80211: allow bw change during channel switch in mesh

From 'IEEE Std 802.11-2020 section 11.8.8.4.1':
  The mesh channel switch may be triggered by the need to avoid
  interference to a detected radar signal, or to reassign mesh STA
  channels to ensure the MBSS connectivity.

  A 20/40 MHz MBSS may be changed to a 20 MHz MBSS and a 20 MHz
  MBSS may be changed to a 20/40 MHz MBSS.

Since the standard allows the change of bandwidth during
the channel switch in mesh, remove the bandwidth check present in
ieee80211_set_csa_beacon.

Fixes: c6da674a ("{nl,cfg,mac}80211: enable the triggering of CSA frame in mesh")
Signed-off-by: Hari Chandrakanthan <quic_haric@quicinc.com>
Link: https://lore.kernel.org/r/1658903549-21218-1-git-send-email-quic_haric@quicinc.comSigned-off-by: Johannes Berg <johannes.berg@intel.com>

net/mac80211/cfg.c

@@ -3683,9 +3683,6 @@ static int ieee80211_set_csa_beacon(struct ieee80211_sub_if_data *sdata,
 	case NL80211_IFTYPE_MESH_POINT: {
 		struct ieee80211_if_mesh *ifmsh = &sdata->u.mesh;
 
-		if (params->chandef.width != sdata->vif.bss_conf.chandef.width)
-			return -EINVAL;
-
 		/* changes into another band are not supported */
 		if (sdata->vif.bss_conf.chandef.chan->band !=
 		    params->chandef.chan->band)