pinctrl: qcom: Add sm8250 lpass lpi pinctrl driver

Add initial pinctrl driver to support pin configuration for
LPASS (Low Power Audio SubSystem) LPI (Low Power Island) pinctrl
on SM8250.

This IP is an additional pin control block for Audio Pins on top the
existing SoC Top level pin-controller.
Hardware setup looks like:

TLMM GPIO[146 - 159] --> LPASS LPI GPIO [0 - 13]

This pin controller has some similarities compared to Top level
msm SoC Pin controller like 'each pin belongs to a single group'
and so on. However this one is intended to control only audio
pins in particular, which can not be configured/touched by the
Top level SoC pin controller except setting them as gpios.
Apart from this, slew rate is also available in this block for
certain pins which are connected to SLIMbus or SoundWire Bus.
Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
Reviewed-by: Bjorn Andersson <bjorn.andersson@linaro.org>
Link: https://lore.kernel.org/r/20201202163443.26499-3-srinivas.kandagatla@linaro.org
[Add some dependencies]
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

drivers/pinctrl/qcom/Kconfig

@@ -265,4 +265,15 @@ config PINCTRL_SM8250
 	  Qualcomm Technologies Inc TLMM block found on the Qualcomm
 	  Technologies Inc SM8250 platform.
 
+config PINCTRL_LPASS_LPI
+	tristate "Qualcomm Technologies Inc LPASS LPI pin controller driver"
+	select PINMUX
+	select PINCONF
+	select GENERIC_PINCONF
+	depends on GPIOLIB
+	help
+	  This is the pinctrl, pinmux, pinconf and gpiolib driver for the
+	  Qualcomm Technologies Inc LPASS (Low Power Audio SubSystem) LPI
+	  (Low Power Island) found on the Qualcomm Technologies Inc SoCs.
+
 endif

drivers/pinctrl/qcom/Makefile

@@ -31,3 +31,4 @@ obj-$(CONFIG_PINCTRL_SDM845) += pinctrl-sdm845.o
 obj-$(CONFIG_PINCTRL_SDX55) += pinctrl-sdx55.o
 obj-$(CONFIG_PINCTRL_SM8150) += pinctrl-sm8150.o
 obj-$(CONFIG_PINCTRL_SM8250) += pinctrl-sm8250.o
+obj-$(CONFIG_PINCTRL_LPASS_LPI) += pinctrl-lpass-lpi.o