Commit 729fc005 authored by Milen Mitkov's avatar Milen Mitkov Committed by Hans Verkuil

media: qcom: camss: Split testgen, RDI and RX for CSID 170

Split the RAW interface (RDI), the CSID receiver (RX)
and test pattern generator (testgen), configurations
for CSID on Titan 170
Signed-off-by: default avatarMilen Mitkov <quic_mmitkov@quicinc.com>
Signed-off-by: default avatarGjorgji Rosikopulos <quic_grosikop@quicinc.com>
Reviewed-by: default avatarBryan O'Donoghue <bryan.odonoghue@linaro.org>
Tested-by: Bryan O'Donoghue <bryan.odonoghue@linaro.org> # sc8280xp/sm8250/sdm845/apq8016
Acked-by: default avatarBryan O'Donoghue <bryan.odonoghue@linaro.org>
Signed-off-by: default avatarHans Verkuil <hverkuil-cisco@xs4all.nl>
[hverkuil: folded https://lore.kernel.org/linux-media/20240626074730.85-1-quic_grosikop@quicinc.com/ into this patch]
parent ad458cb9
......@@ -176,40 +176,51 @@
#define TPG_COLOR_BOX_CFG_MODE 0
#define TPG_COLOR_BOX_PATTERN_SEL 2
static void __csid_configure_stream(struct csid_device *csid, u8 enable, u8 vc)
static void __csid_configure_rx(struct csid_device *csid,
struct csid_phy_config *phy, int vc)
{
struct csid_testgen_config *tg = &csid->testgen;
u32 val;
u32 phy_sel = 0;
u8 lane_cnt = csid->phy.lane_cnt;
/* Source pads matching RDI channels on hardware. Pad 1 -> RDI0, Pad 2 -> RDI1, etc. */
int val;
if (!lane_cnt)
lane_cnt = 4;
val = (lane_cnt - 1) << CSI2_RX_CFG0_NUM_ACTIVE_LANES;
val |= phy->lane_assign << CSI2_RX_CFG0_DL0_INPUT_SEL;
val |= phy->csiphy_id << CSI2_RX_CFG0_PHY_NUM_SEL;
writel_relaxed(val, csid->base + CSID_CSI2_RX_CFG0);
val = 1 << CSI2_RX_CFG1_PACKET_ECC_CORRECTION_EN;
if (vc > 3)
val |= 1 << CSI2_RX_CFG1_VC_MODE;
val |= 1 << CSI2_RX_CFG1_MISR_EN;
writel_relaxed(val, csid->base + CSID_CSI2_RX_CFG1);
}
static void __csid_ctrl_rdi(struct csid_device *csid, int enable, u8 rdi)
{
int val;
if (enable)
val = HALT_CMD_RESUME_AT_FRAME_BOUNDARY << RDI_CTRL_HALT_CMD;
else
val = HALT_CMD_HALT_AT_FRAME_BOUNDARY << RDI_CTRL_HALT_CMD;
writel_relaxed(val, csid->base + CSID_RDI_CTRL(rdi));
}
static void __csid_configure_testgen(struct csid_device *csid, u8 enable, u8 vc)
{
struct csid_testgen_config *tg = &csid->testgen;
struct v4l2_mbus_framefmt *input_format = &csid->fmt[MSM_CSID_PAD_FIRST_SRC + vc];
const struct csid_format_info *format = csid_get_fmt_entry(csid->res->formats->formats,
csid->res->formats->nformats,
input_format->code);
u8 lane_cnt = csid->phy.lane_cnt;
u32 val;
if (!lane_cnt)
lane_cnt = 4;
if (!tg->enabled)
phy_sel = csid->phy.csiphy_id;
if (enable) {
/*
* DT_ID is a two bit bitfield that is concatenated with
* the four least significant bits of the five bit VC
* bitfield to generate an internal CID value.
*
* CSID_RDI_CFG0(vc)
* DT_ID : 28:27
* VC : 26:22
* DT : 21:16
*
* CID : VC 3:0 << 2 | DT_ID 1:0
*/
u8 dt_id = vc & 0x03;
if (tg->enabled) {
/* configure one DT, infinite frames */
val = vc << TPG_VC_CFG0_VC_NUM;
val |= INTELEAVING_MODE_ONE_SHOT << TPG_VC_CFG0_LINE_INTERLEAVING_MODE;
......@@ -237,7 +248,38 @@ static void __csid_configure_stream(struct csid_device *csid, u8 enable, u8 vc)
writel_relaxed(0, csid->base + CSID_TPG_COLOR_BARS_CFG);
writel_relaxed(0, csid->base + CSID_TPG_COLOR_BOX_CFG);
}
val = enable << TPG_CTRL_TEST_EN;
val |= 1 << TPG_CTRL_FS_PKT_EN;
val |= 1 << TPG_CTRL_FE_PKT_EN;
val |= (lane_cnt - 1) << TPG_CTRL_NUM_ACTIVE_LANES;
val |= 0x64 << TPG_CTRL_CYCLES_BETWEEN_PKTS;
val |= 0xA << TPG_CTRL_NUM_TRAIL_BYTES;
writel_relaxed(val, csid->base + CSID_TPG_CTRL);
}
static void __csid_configure_rdi_stream(struct csid_device *csid, u8 enable, u8 vc)
{
/* Source pads matching RDI channels on hardware. Pad 1 -> RDI0, Pad 2 -> RDI1, etc. */
struct v4l2_mbus_framefmt *input_format = &csid->fmt[MSM_CSID_PAD_FIRST_SRC + vc];
const struct csid_format_info *format = csid_get_fmt_entry(csid->res->formats->formats,
csid->res->formats->nformats,
input_format->code);
u32 val;
/*
* DT_ID is a two bit bitfield that is concatenated with
* the four least significant bits of the five bit VC
* bitfield to generate an internal CID value.
*
* CSID_RDI_CFG0(vc)
* DT_ID : 28:27
* VC : 26:22
* DT : 21:16
*
* CID : VC 3:0 << 2 | DT_ID 1:0
*/
u8 dt_id = vc & 0x03;
val = 1 << RDI_CFG0_BYTE_CNTR_EN;
val |= 1 << RDI_CFG0_FORMAT_MEASURE_EN;
......@@ -281,45 +323,24 @@ static void __csid_configure_stream(struct csid_device *csid, u8 enable, u8 vc)
writel_relaxed(val, csid->base + CSID_RDI_CTRL(vc));
val = readl_relaxed(csid->base + CSID_RDI_CFG0(vc));
val |= 1 << RDI_CFG0_ENABLE;
val |= enable << RDI_CFG0_ENABLE;
writel_relaxed(val, csid->base + CSID_RDI_CFG0(vc));
}
if (tg->enabled) {
val = enable << TPG_CTRL_TEST_EN;
val |= 1 << TPG_CTRL_FS_PKT_EN;
val |= 1 << TPG_CTRL_FE_PKT_EN;
val |= (lane_cnt - 1) << TPG_CTRL_NUM_ACTIVE_LANES;
val |= 0x64 << TPG_CTRL_CYCLES_BETWEEN_PKTS;
val |= 0xA << TPG_CTRL_NUM_TRAIL_BYTES;
writel_relaxed(val, csid->base + CSID_TPG_CTRL);
}
val = (lane_cnt - 1) << CSI2_RX_CFG0_NUM_ACTIVE_LANES;
val |= csid->phy.lane_assign << CSI2_RX_CFG0_DL0_INPUT_SEL;
val |= phy_sel << CSI2_RX_CFG0_PHY_NUM_SEL;
writel_relaxed(val, csid->base + CSID_CSI2_RX_CFG0);
val = 1 << CSI2_RX_CFG1_PACKET_ECC_CORRECTION_EN;
if (vc > 3)
val |= 1 << CSI2_RX_CFG1_VC_MODE;
val |= 1 << CSI2_RX_CFG1_MISR_EN;
writel_relaxed(val, csid->base + CSID_CSI2_RX_CFG1);
if (enable)
val = HALT_CMD_RESUME_AT_FRAME_BOUNDARY << RDI_CTRL_HALT_CMD;
else
val = HALT_CMD_HALT_AT_FRAME_BOUNDARY << RDI_CTRL_HALT_CMD;
writel_relaxed(val, csid->base + CSID_RDI_CTRL(vc));
}
static void csid_configure_stream(struct csid_device *csid, u8 enable)
{
struct csid_testgen_config *tg = &csid->testgen;
u8 i;
/* Loop through all enabled VCs and configure stream for each */
for (i = 0; i < MSM_CSID_MAX_SRC_STREAMS; i++)
if (csid->phy.en_vc & BIT(i))
__csid_configure_stream(csid, enable, i);
if (csid->phy.en_vc & BIT(i)) {
if (tg->enabled)
__csid_configure_testgen(csid, enable, i);
__csid_configure_rdi_stream(csid, enable, i);
__csid_configure_rx(csid, &csid->phy, i);
__csid_ctrl_rdi(csid, enable, i);
}
}
static int csid_configure_testgen_pattern(struct csid_device *csid, s32 val)
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment