net: phy: marvell10g: Use get_features to get the PHY abilities

The Alaska family of 10G PHYs has more abilities than the ones listed in
PHY_10GBIT_FULL_FEATURES, the exact list depending on the model.

Make use of the newly introduced .get_features call to build this list,
using genphy_c45_pma_read_abilities to build the list of supported
linkmodes, and adding autoneg ability based on what's reported by the AN
MMD.

.config_init is still used to validate the interface_mode.
Signed-off-by: Maxime Chevallier <maxime.chevallier@bootlin.com>
Reviewed-by: Andrew Lunn <andrew@lunn.ch>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/phy/marvell10g.c

@@ -233,8 +233,6 @@ static int mv3310_resume(struct phy_device *phydev)
 
 static int mv3310_config_init(struct phy_device *phydev)
 {
-	int ret, val;
-
 	/* Check that the PHY interface type is compatible */
 	if (phydev->interface != PHY_INTERFACE_MODE_SGMII &&
 	    phydev->interface != PHY_INTERFACE_MODE_XAUI &&
@@ -242,6 +240,13 @@ static int mv3310_config_init(struct phy_device *phydev)
 	    phydev->interface != PHY_INTERFACE_MODE_10GKR)
 		return -ENODEV;
 
+	return 0;
+}
+
+static int mv3310_get_features(struct phy_device *phydev)
+{
+	int ret, val;
+
 	if (phydev->c45_ids.devices_in_package & MDIO_DEVS_AN) {
 		val = phy_read_mmd(phydev, MDIO_MMD_AN, MDIO_STAT1);
 		if (val < 0)
@@ -416,7 +421,7 @@ static struct phy_driver mv3310_drivers[] = {
 		.phy_id		= 0x002b09aa,
 		.phy_id_mask	= MARVELL_PHY_ID_MASK,
 		.name		= "mv88x3310",
-		.features	= PHY_10GBIT_FEATURES,
+		.get_features	= mv3310_get_features,
 		.soft_reset	= gen10g_no_soft_reset,
 		.config_init	= mv3310_config_init,
 		.probe		= mv3310_probe,