scsi: lpfc: Correct topology type reporting on G7 adapters

Driver missed classifying the chip type for G7 when reporting supported
topologies. This resulted in loop being shown as supported on FC links that
are not supported per the standard.

Add the chip classifications to the topology checks in the driver.
Signed-off-by: Dick Kennedy <dick.kennedy@broadcom.com>
Signed-off-by: James Smart <jsmart2021@gmail.com>
Signed-off-by: Martin K. Petersen <martin.petersen@oracle.com>

drivers/scsi/lpfc/lpfc_attr.c

@@ -3937,7 +3937,8 @@ lpfc_topology_store(struct device *dev, struct device_attribute *attr,
 				val);
 			return -EINVAL;
 		}
-		if (phba->pcidev->device == PCI_DEVICE_ID_LANCER_G6_FC &&
+		if ((phba->pcidev->device == PCI_DEVICE_ID_LANCER_G6_FC ||
+		     phba->pcidev->device == PCI_DEVICE_ID_LANCER_G7_FC) &&
 		    val == 4) {
 			lpfc_printf_vlog(vport, KERN_ERR, LOG_INIT,
 				"3114 Loop mode not supported\n");

drivers/scsi/lpfc/lpfc_mbox.c

@@ -513,9 +513,9 @@ lpfc_init_link(struct lpfc_hba * phba,
 		break;
 	}
 
-	if (phba->pcidev->device == PCI_DEVICE_ID_LANCER_G6_FC &&
+	if ((phba->pcidev->device == PCI_DEVICE_ID_LANCER_G6_FC ||
+	     phba->pcidev->device == PCI_DEVICE_ID_LANCER_G7_FC) &&
 	    mb->un.varInitLnk.link_flags & FLAGS_TOPOLOGY_MODE_LOOP) {
-		/* Failover is not tried for Lancer G6 */
 		mb->un.varInitLnk.link_flags = FLAGS_TOPOLOGY_MODE_PT_PT;
 		phba->cfg_topology = FLAGS_TOPOLOGY_MODE_PT_PT;
 	}