MIPS: NI 169445 board support

Support the National Instruments 169445 board.
Signed-off-by: Nathan Sullivan <nathan.sullivan@ni.com>
Acked-by: Rob Herring <robh@kernel.org>
Cc: devicetree@vger.kernel.org
Cc: linux-mips@linux-mips.org
Cc: linux-kernel@vger.kernel.org
Patchwork: https://patchwork.linux-mips.org/patch/16782/Signed-off-by: Ralf Baechle <ralf@linux-mips.org>

Documentation/devicetree/bindings/mips/ni.txt

+National Instruments MIPS platforms
+
+required root node properties:
+	- compatible: must be "ni,169445"
+
+CPU Nodes
+	- compatible: must be "mti,mips14KEc"

arch/mips/boot/dts/Makefile

@@ -5,6 +5,7 @@ dts-dirs	+= ingenic
 dts-dirs	+= lantiq
 dts-dirs	+= mti
 dts-dirs	+= netlogic
+dts-dirs	+= ni
 dts-dirs	+= pic32
 dts-dirs	+= qca
 dts-dirs	+= ralink

arch/mips/boot/dts/ni/169445.dts

+/dts-v1/;
+
+/ {
+	#address-cells = <1>;
+	#size-cells = <1>;
+	compatible = "ni,169445";
+
+	cpus {
+		#address-cells = <1>;
+		#size-cells = <0>;
+		cpu@0 {
+			device_type = "cpu";
+			compatible = "mti,mips14KEc";
+			clocks = <&baseclk>;
+			reg = <0>;
+		};
+	};
+
+	memory@0 {
+		device_type = "memory";
+		reg = <0x0 0x10000000>;
+	};
+
+	baseclk: baseclock {
+		compatible = "fixed-clock";
+		#clock-cells = <0>;
+		clock-frequency = <50000000>;
+	};
+
+	cpu_intc: interrupt-controller {
+		#address-cells = <0>;
+		compatible = "mti,cpu-interrupt-controller";
+		interrupt-controller;
+		#interrupt-cells = <1>;
+	};
+
+	ahb@1f300000 {
+		compatible = "simple-bus";
+		#address-cells = <1>;
+		#size-cells = <1>;
+		ranges = <0x0 0x1f300000 0x80FFF>;
+
+		gpio1: gpio@10 {
+			compatible = "ni,169445-nand-gpio";
+			reg = <0x10 0x4>;
+			reg-names = "dat";
+			gpio-controller;
+			#gpio-cells = <2>;
+		};
+
+		gpio2: gpio@14 {
+			compatible = "ni,169445-nand-gpio";
+			reg = <0x14 0x4>;
+			reg-names = "dat";
+			gpio-controller;
+			#gpio-cells = <2>;
+			no-output;
+		};
+
+		nand@0 {
+			compatible = "gpio-control-nand";
+			nand-on-flash-bbt;
+			nand-ecc-mode = "soft_bch";
+			nand-ecc-step-size = <512>;
+			nand-ecc-strength = <4>;
+			reg = <0x0 4>;
+			gpios = <&gpio2 0 0>, /* rdy */
+				<&gpio1 1 0>, /* nce */
+				<&gpio1 2 0>, /* ale */
+				<&gpio1 3 0>, /* cle */
+				<&gpio1 4 0>; /* nwp */
+		};
+
+		serial@80000 {
+			compatible = "ns16550a";
+			reg = <0x80000 0x1000>;
+			interrupt-parent = <&cpu_intc>;
+			interrupts = <6>;
+			clocks = <&baseclk>;
+			reg-shift = <0>;
+		};
+
+		ethernet@40000 {
+			compatible = "snps,dwmac-4.10a";
+			interrupt-parent = <&cpu_intc>;
+			interrupts = <5>;
+			interrupt-names = "macirq";
+			reg = <0x40000 0x2000>;
+			clock-names = "stmmaceth", "pclk";
+			clocks = <&baseclk>, <&baseclk>;
+
+			phy-mode = "rgmii";
+
+			fixed-link {
+				speed = <1000>;
+				full-duplex;
+			};
+		};
+	};
+};

arch/mips/boot/dts/ni/Makefile

+dtb-$(CONFIG_FIT_IMAGE_FDT_NI169445)	+= 169445.dtb
+
+# Force kbuild to make empty built-in.o if necessary
+obj-					+= dummy.o
+
+always					:= $(dtb-y)
+clean-files				:= *.dtb *.dtb.S

arch/mips/configs/generic/board-ni169445.config

+CONFIG_FIT_IMAGE_FDT_NI169445=y
+
+CONFIG_SERIAL_8250=y
+CONFIG_SERIAL_8250_CONSOLE=y
+CONFIG_SERIAL_OF_PLATFORM=y
+
+CONFIG_GPIOLIB=y
+CONFIG_GPIO_SYSFS=y
+CONFIG_GPIO_GENERIC_PLATFORM=y
+
+CONFIG_MTD=y
+CONFIG_MTD_BLOCK=y
+CONFIG_MTD_CMDLINE_PARTS=y
+
+CONFIG_MTD_NAND_ECC=y
+CONFIG_MTD_NAND_ECC_BCH=y
+CONFIG_MTD_NAND=y
+CONFIG_MTD_NAND_GPIO=y
+CONFIG_MTD_NAND_IDS=y
+
+CONFIG_MTD_UBI=y
+CONFIG_MTD_UBI_BLOCK=y
+
+CONFIG_NETDEVICES=y
+CONFIG_STMMAC_ETH=y
+CONFIG_STMMAC_PLATFORM=y
+CONFIG_DWMAC_GENERIC=y

arch/mips/generic/Kconfig

@@ -36,4 +36,10 @@ config FIT_IMAGE_FDT_BOSTON
 	  enable this if you wish to boot on a MIPS Boston board, as it is
 	  expected by the bootloader.
 
+config FIT_IMAGE_FDT_NI169445
+	bool "Include FDT for NI 169445"
+	help
+	  Enable this to include the FDT for the 169445 platform from
+	  National Instruments in the FIT kernel image.
+
 endif

arch/mips/generic/vmlinux.its.S

@@ -54,3 +54,28 @@
 	};
 };
 #endif /* CONFIG_FIT_IMAGE_FDT_BOSTON */
+
+#ifdef CONFIG_FIT_IMAGE_FDT_NI169445
+/ {
+	images {
+		fdt@ni169445 {
+			description = "NI 169445 device tree";
+			data = /incbin/("boot/dts/ni/169445.dtb");
+			type = "flat_dt";
+			arch = "mips";
+			compression = "none";
+			hash@0 {
+				algo = "sha1";
+			};
+		};
+	};
+
+	configurations {
+		conf@ni169445 {
+			description = "NI 169445 Linux Kernel";
+			kernel = "kernel@0";
+			fdt = "fdt@ni169445";
+		};
+	};
+};
+#endif /* CONFIG_FIT_IMAGE_FDT_NI169445 */