Commit 7c7f1f29 authored by Andrew Vasquez's avatar Andrew Vasquez Committed by James Bottomley

[SCSI] qla2xxx: Correct needless clean-up resets during shutdown.

There's no point in hitting the RISC with what will most
assuredly be an unsucessful reset of the RISC hardware if the
initial stop-firmware mailbox command fails with a time-out
status.  Instead, to avoid what could amount to a lengthy
stop-firmware/detect-failure/reset-risc loop, continue with
driver unloading and discard the stop-firmware requirement.
Signed-off-by: default avatarAndrew Vasquez <andrew.vasquez@qlogic.com>
Signed-off-by: default avatarJames Bottomley <James.Bottomley@HansenPartnership.com>
parent ba1cb461
......@@ -4022,7 +4022,8 @@ qla2x00_try_to_stop_firmware(scsi_qla_host_t *ha)
return;
ret = qla2x00_stop_firmware(ha);
for (retries = 5; ret != QLA_SUCCESS && retries ; retries--) {
for (retries = 5; ret != QLA_SUCCESS && ret != QLA_FUNCTION_TIMEOUT &&
retries ; retries--) {
qla2x00_reset_chip(ha);
if (qla2x00_chip_diag(ha) != QLA_SUCCESS)
continue;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment