habanalabs: support DEVICE_UNUSABLE error indication from FW

In case of multiple ECC errors, FW will set the DEVICE_UNUSABLE bit.
On boot-up, the driver will therefore fail inserting the device.
Signed-off-by: Koby Elbaz <kelbaz@habana.ai>
Reviewed-by: Oded Gabbay <ogabbay@kernel.org>
Signed-off-by: Oded Gabbay <ogabbay@kernel.org>

drivers/misc/habanalabs/common/firmware_if.c

@@ -342,6 +342,9 @@ static int fw_read_errors(struct hl_device *hdev, u32 boot_err0_reg,
 		dev_err(hdev->dev, "Device boot error - eFuse failure\n");
 	if (err_val & CPU_BOOT_ERR0_PLL_FAIL)
 		dev_err(hdev->dev, "Device boot error - PLL failure\n");
+	if (err_val & CPU_BOOT_ERR0_DEVICE_UNUSABLE_FAIL)
+		dev_err(hdev->dev,
+			"Device boot error - device unusable failure\n");
 
 	security_val = RREG32(cpu_security_boot_status_reg);
 	if (security_val & CPU_BOOT_DEV_STS0_ENABLED)

drivers/misc/habanalabs/include/common/hl_boot_if.h

@@ -73,6 +73,9 @@
  * CPU_BOOT_ERR0_PLL_FAIL		PLL settings failed, meaning that one
  *					of the PLLs remains in REF_CLK
  *
+ * CPU_BOOT_ERR0_DEVICE_UNUSABLE_FAIL	Device is unusable and customer support
+ *					should be contacted.
+ *
  * CPU_BOOT_ERR0_ENABLED		Error registers enabled.
  *					This is a main indication that the
  *					running FW populates the error
@@ -92,6 +95,7 @@
 #define CPU_BOOT_ERR0_PRI_IMG_VER_FAIL		(1 << 10)
 #define CPU_BOOT_ERR0_SEC_IMG_VER_FAIL		(1 << 11)
 #define CPU_BOOT_ERR0_PLL_FAIL			(1 << 12)
+#define CPU_BOOT_ERR0_DEVICE_UNUSABLE_FAIL	(1 << 13)
 #define CPU_BOOT_ERR0_ENABLED			(1 << 31)
 
 /*