Commit 7da3f901 authored by Russell King (Oracle)'s avatar Russell King (Oracle) Committed by Jakub Kicinski

net: mtk_eth_soc: correct 802.3z speed setting

Phylink does not guarantee that state->speed will be set correctly in
the mac_config() call, so it's a bug that the driver makes use of it.
Moreover, it is making use of it in a function that is only ever called
for 1000BASE-X and 2500BASE-X which operate at a fixed speed which
happens to be the same setting irrespective of the interface mode. We
can simply remove the switch statement and just set the SGMII interface
speed.
Signed-off-by: default avatarRussell King (Oracle) <rmk+kernel@armlinux.org.uk>
Signed-off-by: default avatarJakub Kicinski <kuba@kernel.org>
parent bc5e93e0
......@@ -34,6 +34,7 @@ int mtk_sgmii_init(struct mtk_sgmii *ss, struct device_node *r, u32 ana_rgc3)
return 0;
}
/* For SGMII interface mode */
int mtk_sgmii_setup_mode_an(struct mtk_sgmii *ss, int id)
{
unsigned int val;
......@@ -60,6 +61,9 @@ int mtk_sgmii_setup_mode_an(struct mtk_sgmii *ss, int id)
return 0;
}
/* For 1000BASE-X and 2500BASE-X interface modes, which operate at a
* fixed speed.
*/
int mtk_sgmii_setup_mode_force(struct mtk_sgmii *ss, int id,
const struct phylink_link_state *state)
{
......@@ -82,19 +86,7 @@ int mtk_sgmii_setup_mode_force(struct mtk_sgmii *ss, int id,
/* SGMII force mode setting */
regmap_read(ss->regmap[id], SGMSYS_SGMII_MODE, &val);
val &= ~SGMII_IF_MODE_MASK;
switch (state->speed) {
case SPEED_10:
val |= SGMII_SPEED_10;
break;
case SPEED_100:
val |= SGMII_SPEED_100;
break;
case SPEED_2500:
case SPEED_1000:
val |= SGMII_SPEED_1000;
break;
}
if (state->duplex == DUPLEX_FULL)
val |= SGMII_DUPLEX_FULL;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment