Commit 81906791 authored by Stephen Hemminger's avatar Stephen Hemminger Committed by Jeff Garzik

sky2: transmit timeout

The transmit timeout code could hang, and it would not clear out
problems if the hardware was stuck.  Change the code to effectively do
a device down/up similar to the suspend/resume code.
Signed-off-by: default avatarStephen Hemminger <shemminger@linux-foundation.org>
Signed-off-by: default avatarJeff Garzik <jeff@garzik.org>
parent da4c1ff4
......@@ -1866,16 +1866,13 @@ static void sky2_phy_intr(struct sky2_hw *hw, unsigned port)
spin_unlock(&sky2->phy_lock);
}
/* Transmit timeout is only called if we are running, carrier is up
* and tx queue is full (stopped).
* Called with netif_tx_lock held.
*/
static void sky2_tx_timeout(struct net_device *dev)
{
struct sky2_port *sky2 = netdev_priv(dev);
struct sky2_hw *hw = sky2->hw;
u32 imask;
if (netif_msg_timer(sky2))
printk(KERN_ERR PFX "%s: tx timeout\n", dev->name);
......@@ -1885,19 +1882,8 @@ static void sky2_tx_timeout(struct net_device *dev)
sky2_read16(hw, sky2->port == 0 ? STAT_TXA1_RIDX : STAT_TXA2_RIDX),
sky2_read16(hw, Q_ADDR(txqaddr[sky2->port], Q_DONE)));
imask = sky2_read32(hw, B0_IMSK); /* block IRQ in hw */
sky2_write32(hw, B0_IMSK, 0);
sky2_read32(hw, B0_IMSK);
netif_poll_disable(hw->dev[0]); /* stop NAPI poll */
synchronize_irq(hw->pdev->irq);
netif_start_queue(dev); /* don't wakeup during flush */
sky2_tx_complete(sky2, sky2->tx_prod); /* Flush transmit queue */
sky2_write32(hw, B0_IMSK, imask);
sky2_phy_reinit(sky2); /* this clears flow control etc */
/* can't restart safely under softirq */
schedule_work(&hw->restart_work);
}
static int sky2_change_mtu(struct net_device *dev, int new_mtu)
......@@ -2651,6 +2637,49 @@ static void sky2_reset(struct sky2_hw *hw)
sky2_write8(hw, STAT_ISR_TIMER_CTRL, TIM_START);
}
static void sky2_restart(struct work_struct *work)
{
struct sky2_hw *hw = container_of(work, struct sky2_hw, restart_work);
struct net_device *dev;
int i, err;
dev_dbg(&hw->pdev->dev, "restarting\n");
del_timer_sync(&hw->idle_timer);
rtnl_lock();
sky2_write32(hw, B0_IMSK, 0);
sky2_read32(hw, B0_IMSK);
netif_poll_disable(hw->dev[0]);
for (i = 0; i < hw->ports; i++) {
dev = hw->dev[i];
if (netif_running(dev))
sky2_down(dev);
}
sky2_reset(hw);
sky2_write32(hw, B0_IMSK, Y2_IS_BASE);
netif_poll_enable(hw->dev[0]);
for (i = 0; i < hw->ports; i++) {
dev = hw->dev[i];
if (netif_running(dev)) {
err = sky2_up(dev);
if (err) {
printk(KERN_INFO PFX "%s: could not restart %d\n",
dev->name, err);
dev_close(dev);
}
}
}
sky2_idle_start(hw);
rtnl_unlock();
}
static inline u8 sky2_wol_supported(const struct sky2_hw *hw)
{
return sky2_is_copper(hw) ? (WAKE_PHY | WAKE_MAGIC) : 0;
......@@ -3613,6 +3642,8 @@ static int __devinit sky2_probe(struct pci_dev *pdev,
}
setup_timer(&hw->idle_timer, sky2_idle, (unsigned long) hw);
INIT_WORK(&hw->restart_work, sky2_restart);
sky2_idle_start(hw);
pci_set_drvdata(pdev, hw);
......@@ -3649,6 +3680,8 @@ static void __devexit sky2_remove(struct pci_dev *pdev)
del_timer_sync(&hw->idle_timer);
flush_scheduled_work();
sky2_write32(hw, B0_IMSK, 0);
synchronize_irq(hw->pdev->irq);
......
......@@ -1933,6 +1933,7 @@ struct sky2_hw {
dma_addr_t st_dma;
struct timer_list idle_timer;
struct work_struct restart_work;
int msi;
wait_queue_head_t msi_wait;
};
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment