Commit 86a5906e authored by Robin Murphy's avatar Robin Murphy Committed by Catalin Marinas

arm64: Fix build with CONFIG_ZONE_DMA=n

Trying to build with CONFIG_ZONE_DMA=n leaves visible references
to the now-undefined ZONE_DMA, resulting in a syntax error.

Hide the references behind an #ifdef instead of using IS_ENABLED.
Signed-off-by: default avatarRobin Murphy <robin.murphy@arm.com>
Signed-off-by: default avatarCatalin Marinas <catalin.marinas@arm.com>
parent 5accd17d
...@@ -86,10 +86,10 @@ static void __init zone_sizes_init(unsigned long min, unsigned long max) ...@@ -86,10 +86,10 @@ static void __init zone_sizes_init(unsigned long min, unsigned long max)
memset(zone_size, 0, sizeof(zone_size)); memset(zone_size, 0, sizeof(zone_size));
/* 4GB maximum for 32-bit only capable devices */ /* 4GB maximum for 32-bit only capable devices */
if (IS_ENABLED(CONFIG_ZONE_DMA)) { #ifdef CONFIG_ZONE_DMA
max_dma = PFN_DOWN(arm64_dma_phys_limit); max_dma = PFN_DOWN(arm64_dma_phys_limit);
zone_size[ZONE_DMA] = max_dma - min; zone_size[ZONE_DMA] = max_dma - min;
} #endif
zone_size[ZONE_NORMAL] = max - max_dma; zone_size[ZONE_NORMAL] = max - max_dma;
memcpy(zhole_size, zone_size, sizeof(zhole_size)); memcpy(zhole_size, zone_size, sizeof(zhole_size));
...@@ -101,11 +101,12 @@ static void __init zone_sizes_init(unsigned long min, unsigned long max) ...@@ -101,11 +101,12 @@ static void __init zone_sizes_init(unsigned long min, unsigned long max)
if (start >= max) if (start >= max)
continue; continue;
if (IS_ENABLED(CONFIG_ZONE_DMA) && start < max_dma) { #ifdef CONFIG_ZONE_DMA
if (start < max_dma) {
unsigned long dma_end = min(end, max_dma); unsigned long dma_end = min(end, max_dma);
zhole_size[ZONE_DMA] -= dma_end - start; zhole_size[ZONE_DMA] -= dma_end - start;
} }
#endif
if (end > max_dma) { if (end > max_dma) {
unsigned long normal_end = min(end, max); unsigned long normal_end = min(end, max);
unsigned long normal_start = max(start, max_dma); unsigned long normal_start = max(start, max_dma);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment