ide: don't set PIO mode on pre-EIDE drives

Fix handling of the PIO modes for the pre-EIDE drives that did not support
the PIO Flow Control Transfer Mode value (00001 nnn) of the Set Transfer Mode
feature by skipping the actual mode programming.
Signed-off-by: Sergei Shtylyov <sshtylyov@ru.mvista.com>
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>

drivers/ide/ide-iops.c

@@ -756,7 +756,7 @@ int ide_driveid_update(ide_drive_t *drive)
 int ide_config_drive_speed(ide_drive_t *drive, u8 speed)
 {
 	ide_hwif_t *hwif = drive->hwif;
-	int error;
+	int error = 0;
 	u8 stat;
 
 //	while (HWGROUP(drive)->busy)
@@ -767,6 +767,10 @@ int ide_config_drive_speed(ide_drive_t *drive, u8 speed)
 		hwif->dma_host_off(drive);
 #endif
 
+	/* Skip setting PIO flow-control modes on pre-EIDE drives */
+	if ((speed & 0xf8) == XFER_PIO_0 && !(drive->id->capability & 0x08))
+		goto skip;
+
 	/*
 	 * Don't use ide_wait_cmd here - it will
 	 * attempt to set_geometry and recalibrate,
@@ -814,6 +818,7 @@ int ide_config_drive_speed(ide_drive_t *drive, u8 speed)
 	drive->id->dma_mword &= ~0x0F00;
 	drive->id->dma_1word &= ~0x0F00;
 
+ skip:
 #ifdef CONFIG_BLK_DEV_IDEDMA
 	if (speed >= XFER_SW_DMA_0)
 		hwif->dma_host_on(drive);