spi: Add Flag to Enable Slave Select with GPIO Chip Select.

Some SPI masters require slave selection before the transfer
can begin [1]. The SPI framework currently selects the chip using
either 1) the internal CS mechanism or 2) the GPIO CS, but not both.

This patch adds a new master->flags define to indicate both the GPIO
CS and the internal chip select mechanism should be used.

Tested On:
    Altera CycloneV development kit
    Compile tested for build errors on x86_64 (allyesconfigs)

[1] DesignWare dw_apb_ssi Databook, Version 3.20a (page 39)
Signed-off-by: Thor Thayer <tthayer@opensource.altera.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

drivers/spi/spi.c

@@ -697,10 +697,15 @@ static void spi_set_cs(struct spi_device *spi, bool enable)
 	if (spi->mode & SPI_CS_HIGH)
 		enable = !enable;
 
-	if (gpio_is_valid(spi->cs_gpio))
+	if (gpio_is_valid(spi->cs_gpio)) {
 		gpio_set_value(spi->cs_gpio, !enable);
-	else if (spi->master->set_cs)
+		/* Some SPI masters need both GPIO CS & slave_select */
+		if ((spi->master->flags & SPI_MASTER_GPIO_SS) &&
+		    spi->master->set_cs)
 			spi->master->set_cs(spi, !enable);
+	} else if (spi->master->set_cs) {
+		spi->master->set_cs(spi, !enable);
+	}
 }
 
 #ifdef CONFIG_HAS_DMA

include/linux/spi/spi.h

@@ -442,6 +442,7 @@ struct spi_master {
 #define SPI_MASTER_NO_TX	BIT(2)		/* can't do buffer write */
 #define SPI_MASTER_MUST_RX      BIT(3)		/* requires rx */
 #define SPI_MASTER_MUST_TX      BIT(4)		/* requires tx */
+#define SPI_MASTER_GPIO_SS      BIT(5)		/* GPIO CS must select slave */
 
 	/*
 	 * on some hardware transfer / message size may be constrained