Commit 9b443e3d authored by Michael Grzeschik's avatar Michael Grzeschik Committed by Mark Brown

ASoC: fsl-ssi: imx-pcm-fiq bugfix

imx-pcm-fiq is checking for TE RE bits, so enable them only if
necessary.
Signed-off-by: default avatarMichael Grzeschik <m.grzeschik@pengutronix.de>
Signed-off-by: default avatarMark Brown <broonie@linaro.org>
parent f8fdf537
......@@ -382,31 +382,12 @@ static int fsl_ssi_setup(struct fsl_ssi_private *ssi_private)
CCSR_SSI_SFCSR_TFWM1(wm) | CCSR_SSI_SFCSR_RFWM1(wm),
&ssi->sfcsr);
/*
* For non-ac97 setups, we keep the SSI disabled because if we enable
* it, then the DMA controller will start. It's not supposed to start
* until the SCR.TE (or SCR.RE) bit is set, but it does anyway. The DMA
* controller will transfer one "BWC" of data (i.e. the amount of data
* that the MR.BWC bits are set to). The reason this is bad is because
* at this point, the PCM driver has not finished initializing the DMA
* controller.
*/
/*
* For ac97 interrupts are enabled with the startup of the substream
* because it is also running without an active substream. Normally SSI
* is only enabled when there is a substream.
*/
if (!ssi_private->imx_ac97) {
/* Enable the interrupts and DMA requests */
if (ssi_private->use_dma)
write_ssi(SIER_FLAGS, &ssi->sier);
else
write_ssi(CCSR_SSI_SIER_TIE | CCSR_SSI_SIER_TFE0_EN |
CCSR_SSI_SIER_RIE |
CCSR_SSI_SIER_RFF0_EN, &ssi->sier);
} else {
if (ssi_private->imx_ac97) {
/*
* Setup the clock control register
*/
......@@ -574,6 +555,27 @@ static int fsl_ssi_trigger(struct snd_pcm_substream *substream, int cmd,
struct snd_soc_pcm_runtime *rtd = substream->private_data;
struct fsl_ssi_private *ssi_private = snd_soc_dai_get_drvdata(rtd->cpu_dai);
struct ccsr_ssi __iomem *ssi = ssi_private->ssi;
unsigned int sier_bits;
/*
* Enable only the interrupts and DMA requests
* that are needed for the channel. As the fiq
* is polling for this bits, we have to ensure
* that this are aligned with the preallocated
* buffers
*/
if (substream->stream == SNDRV_PCM_STREAM_PLAYBACK) {
if (ssi_private->use_dma)
sier_bits = SIER_FLAGS;
else
sier_bits = CCSR_SSI_SIER_TIE | CCSR_SSI_SIER_TFE0_EN;
} else {
if (ssi_private->use_dma)
sier_bits = SIER_FLAGS;
else
sier_bits = CCSR_SSI_SIER_RIE | CCSR_SSI_SIER_RFF0_EN;
}
switch (cmd) {
case SNDRV_PCM_TRIGGER_START:
......@@ -602,6 +604,8 @@ static int fsl_ssi_trigger(struct snd_pcm_substream *substream, int cmd,
return -EINVAL;
}
write_ssi(sier_bits, &ssi->sier);
return 0;
}
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment