Commit 9d4dfe4a authored by Kalesh AP's avatar Kalesh AP Committed by David S. Miller

be2net: re-enable vlan filtering mode asap

While adding vlans, when the HW limit of vlan filters is reached, the
driver enables vlan promiscuous mode.
Similarily, while removing vlans, the driver must re-enable HW filtering
as soon as the number of vlan filters is within the HW limit.
Signed-off-by: default avatarKalesh AP <kalesh.purayil@emulex.com>
Signed-off-by: default avatarSathya Perla <sathya.perla@emulex.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent bec84e6b
...@@ -1172,20 +1172,15 @@ static int be_vlan_add_vid(struct net_device *netdev, __be16 proto, u16 vid) ...@@ -1172,20 +1172,15 @@ static int be_vlan_add_vid(struct net_device *netdev, __be16 proto, u16 vid)
static int be_vlan_rem_vid(struct net_device *netdev, __be16 proto, u16 vid) static int be_vlan_rem_vid(struct net_device *netdev, __be16 proto, u16 vid)
{ {
struct be_adapter *adapter = netdev_priv(netdev); struct be_adapter *adapter = netdev_priv(netdev);
int status = 0;
/* Packets with VID 0 are always received by Lancer by default */ /* Packets with VID 0 are always received by Lancer by default */
if (lancer_chip(adapter) && vid == 0) if (lancer_chip(adapter) && vid == 0)
goto ret; return 0;
clear_bit(vid, adapter->vids); clear_bit(vid, adapter->vids);
status = be_vid_config(adapter);
if (!status)
adapter->vlans_added--; adapter->vlans_added--;
else
set_bit(vid, adapter->vids); return be_vid_config(adapter);
ret:
return status;
} }
static void be_clear_promisc(struct be_adapter *adapter) static void be_clear_promisc(struct be_adapter *adapter)
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment