Commit 9f72520f authored by Lars-Peter Clausen's avatar Lars-Peter Clausen Committed by Jonathan Cameron

staging:iio:ad7606: Remove default device configuration from platform data

While for some very selected setups it might be useful to be able to
provide default configuration data via the platform data, generally this
becomes very impractical as the number of configuration options increases.
So the general policy is to use the power-on default values of the device
and let the application using the device configure it according to its
needs.

Implement this scheme for the ad7606 driver by removing support for
specifying a default configuration via the platform data.
Signed-off-by: default avatarLars-Peter Clausen <lars@metafoo.de>
Signed-off-by: default avatarJonathan Cameron <jic23@kernel.org>
parent 063a51c5
...@@ -15,8 +15,6 @@ ...@@ -15,8 +15,6 @@
/** /**
* struct ad7606_platform_data - platform/board specific information * struct ad7606_platform_data - platform/board specific information
* @default_os: default oversampling value {0, 2, 4, 8, 16, 32, 64}
* @default_range: default range +/-{5000, 10000} mVolt
* @gpio_convst: number of gpio connected to the CONVST pin * @gpio_convst: number of gpio connected to the CONVST pin
* @gpio_reset: gpio connected to the RESET pin, if not used set to -1 * @gpio_reset: gpio connected to the RESET pin, if not used set to -1
* @gpio_range: gpio connected to the RANGE pin, if not used set to -1 * @gpio_range: gpio connected to the RANGE pin, if not used set to -1
...@@ -28,8 +26,6 @@ ...@@ -28,8 +26,6 @@
*/ */
struct ad7606_platform_data { struct ad7606_platform_data {
unsigned int default_os;
unsigned int default_range;
unsigned int gpio_convst; unsigned int gpio_convst;
unsigned int gpio_reset; unsigned int gpio_reset;
unsigned int gpio_range; unsigned int gpio_range;
......
...@@ -452,16 +452,8 @@ struct iio_dev *ad7606_probe(struct device *dev, int irq, ...@@ -452,16 +452,8 @@ struct iio_dev *ad7606_probe(struct device *dev, int irq,
st->dev = dev; st->dev = dev;
st->bops = bops; st->bops = bops;
st->base_address = base_address; st->base_address = base_address;
st->range = pdata->default_range == 10000 ? 10000 : 5000; st->range = 5000;
ret = ad7606_oversampling_get_index(pdata->default_os);
if (ret < 0) {
dev_warn(dev, "oversampling %d is not supported\n",
pdata->default_os);
st->oversampling = 0; st->oversampling = 0;
} else {
st->oversampling = pdata->default_os;
}
st->reg = devm_regulator_get(dev, "vcc"); st->reg = devm_regulator_get(dev, "vcc");
if (!IS_ERR(st->reg)) { if (!IS_ERR(st->reg)) {
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment