eth: fec: Fix lost promiscuous mode after reconnecting cable

[ Upstream commit 84fe6182 ]

If the Freescale fec is in promiscuous mode and network cable is
reconnected then the promiscuous mode get lost. The problem is caused
by a too soon call of set_multicast_list to re-enable promisc mode.
The FEC_R_CNTRL register changes are overwritten by fec_restart.

This patch fixes this by moving the call behind the init of FEC_R_CNTRL
register in fec_restart.

Successful tested on a i.MX28 board.
Signed-off-by: Stefan Wahren <stefan.wahren@i2se.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Signed-off-by: Jiri Slaby <jslaby@suse.cz>

drivers/net/ethernet/freescale/fec_main.c

@@ -525,13 +525,6 @@ fec_restart(struct net_device *ndev, int duplex)
 	/* Clear any outstanding interrupt. */
 	writel(0xffc00000, fep->hwp + FEC_IEVENT);
 
-	/* Setup multicast filter. */
-	set_multicast_list(ndev);
-#ifndef CONFIG_M5272
-	writel(0, fep->hwp + FEC_HASH_TABLE_HIGH);
-	writel(0, fep->hwp + FEC_HASH_TABLE_LOW);
-#endif
-
 	/* Set maximum receive buffer size. */
 	writel(PKT_MAXBLR_SIZE, fep->hwp + FEC_R_BUFF_SIZE);
 
@@ -652,6 +645,13 @@ fec_restart(struct net_device *ndev, int duplex)
 
 	writel(rcntl, fep->hwp + FEC_R_CNTRL);
 
+	/* Setup multicast filter. */
+	set_multicast_list(ndev);
+#ifndef CONFIG_M5272
+	writel(0, fep->hwp + FEC_HASH_TABLE_HIGH);
+	writel(0, fep->hwp + FEC_HASH_TABLE_LOW);
+#endif
+
 	if (id_entry->driver_data & FEC_QUIRK_ENET_MAC) {
 		/* enable ENET endian swap */
 		ecntl |= (1 << 8);