Automerge

Documentation/scsi/dc395x.txt

+README file for the dc395x SCSI driver
+==========================================
+
+Status
+------
+The driver has been tested with CD-R and CD-R/W drives. These should
+be safe to use. Testing with hard disks has not been done to any
+great degree and caution should be exercised if you want to attempt
+to use this driver with hard disks.
+
+This is a 2.5 only driver. For a 2.4 driver please see the original
+driver (which this driver started from) at
+http://www.garloff.de/kurt/linux/dc395/
+
+Problems, questions and patches should be submitted to the mailing
+list. Details on the list, including archives, are available at
+http://lists.twibble.org/mailman/listinfo/dc395x/
+
+Parameters
+----------
+The driver uses the settings from the EEPROM set in the SCSI BIOS 
+setup. If there is no EEPROM, the driver uses default values.
+Both can be overriden by command line parameters (module or kernel
+parameters).
+
+The syntax is as follows:
+ dc395x = AdapterID, SpeedIdx, DevMode, AdaptMode, Tags, DelayReset
+
+AdapterID : Host Adapter SCSI ID
+SpeedIdx  : 0,1,...7 = 20,13.3,10,8,6.7,5.8,5,4 MHz               [ 7]
+DevMode   : Bitmap for Dev Cfg                                    [63]
+AdaptMode : Bitmap for Adapter Cfg                                [47]
+Tags      : The number of tags is 1<<x, if x has been specified   [ 4]
+DelayReset: The seconds to not accept commands after a SCSI Reset [ 1]
+
+DevMode bit definition:
+   Bit Val(hex) Val(dec)  Meaning
+   *0	 0x01	    1	  Parity check
+   *1	 0x02	    2	  Synchronous Negotiation
+   *2	 0x04	    4	  Disconnection
+   *3	 0x08	    8	  Send Start command on startup. (Not used)
+   *4	 0x10	   16	  Tagged Command Queueing
+   *5	 0x20	   32	  Wide Negotiation
+
+AdaptMode bit definition
+   Bit Val(hex) Val(dec)  Meaning
+   *0	 0x01	    1	  Support more than two drives. (Not used)
+   *1	 0x02	    2	  Use DOS compatible mapping for HDs greater than 1GB.
+   *2	 0x04	    4	  Reset SCSI Bus on startup.
+   *3	 0x08	    8	  Active Negation: Improves SCSI Bus noise immunity.
+    4	 0x10	   16	  Immediate return on BIOS seek command. (Not used)
+ (*)5	 0x20	   32	  Check for LUNs >= 1.
+
+If you set AdapterID to -1, the adapter will use conservative
+("safe") default settings instead; more precisely, dc395x=-1 is a
+shortcut for dc395x=7,4,9,15,2,10
+
+If you specify -2 for a value, it will be ignored. You don't need to
+specify all six parameters.
+
+Copyright
+---------
+The driver is free software. It is protected by the GNU General Public
+License (GPL). Please read it, before using this driver. It should be
+included in your kernel sources and with your distribution. It carries the
+filename COPYING. If you don't have it, please ask me to send you one by
+email.
+Note: The GNU GPL says also something about warranty and liability. 
+Please be aware the following: While we do my best to provide a working and
+reliable driver, there is a chance, that it will kill your valuable data. 
+We refuse to take any responsibility for that. The driver is provided as-is
+and YOU USE IT AT YOUR OWN RESPONSIBILITY.

MAINTAINERS

@@ -505,6 +505,17 @@ W:	http://www.qsl.net/dl1bke/
 L:	linux-hams@vger.kernel.org
 S:	Maintained
 
+DC395x SCSI driver
+P:	Oliver Neukum
+M:	oliver@neukum.name
+P:	Ali Akcaagac
+M:	aliakc@web.de
+P:	Jamie Lenehan
+M:	lenehan@twibble.org
+W:	http://twibble.org/dist/dc395x/
+L:	http://lists.twibble.org/mailman/listinfo/dc395x/
+S:	Maintained
+
 DC390/AM53C974 SCSI driver
 P:	Kurt Garloff
 M:	garloff@suse.de

drivers/scsi/Kconfig

@@ -1390,6 +1390,23 @@ config SCSI_SYM53C416
 	  read <file:Documentation/modules.txt>. The module will be called
 	  sym53c416.
 
+config SCSI_DC395x
+	tristate "Tekram DC395(U/UW/F) and DC315(U) SCSI support (EXPERIMENTAL)"
+	depends on EXPERIMENTAL && PCI && SCSI
+	---help---
+	  This driver supports PCI SCSI host adapters based on the ASIC
+	  TRM-S1040 chip, e.g Tekram DC395(U/UW/F) and DC315(U) variants.
+
+	  This driver works, but is still in experimental status. So better
+	  have a bootable disk and a backup in case of emergency.
+
+	  Documentation can be found in <file:Documentation/scsi/dc395x.txt>.
+
+	  If you want to compile this driver as a module ( = code which can be
+	  inserted in and removed from the running kernel whenever you want),
+	  say M here and read <file:Documentation/modules.txt>.  The module
+	  will be called dc395x.
+
 config SCSI_DC390T
 	tristate "Tekram DC390(T) and Am53/79C974 SCSI support"
 	depends on PCI && SCSI

drivers/scsi/Makefile

@@ -88,6 +88,7 @@ obj-$(CONFIG_SCSI_7000FASST)	+= wd7000.o
 obj-$(CONFIG_SCSI_MCA_53C9X)	+= NCR53C9x.o	mca_53c9x.o
 obj-$(CONFIG_SCSI_IBMMCA)	+= ibmmca.o
 obj-$(CONFIG_SCSI_EATA)		+= eata.o
+obj-$(CONFIG_SCSI_DC395x)	+= dc395x.o
 obj-$(CONFIG_SCSI_DC390T)	+= tmscsim.o
 obj-$(CONFIG_SCSI_AM53C974)	+= AM53C974.o
 obj-$(CONFIG_SCSI_MEGARAID)	+= megaraid.o