dt-bindings: leds: aw200xx: Remove property "awinic,display-rows"

Get rid of the property "awinic,display-rows" and calculate it
in the driver using led definition nodes.
Signed-off-by: George Stark <gnstark@salutedevices.com>
Signed-off-by: Dmitry Rokosov <ddrokosov@salutedevices.com>
Acked-by: Rob Herring <robh@kernel.org>
Link: https://lore.kernel.org/r/20231125200519.1750-6-ddrokosov@salutedevices.comSigned-off-by: Lee Jones <lee@kernel.org>

Documentation/devicetree/bindings/leds/awinic,aw200xx.yaml

@@ -36,11 +36,6 @@ properties:
   "#size-cells":
     const: 0
 
-  awinic,display-rows:
-    $ref: /schemas/types.yaml#/definitions/uint32
-    description:
-      Leds matrix size
-
   enable-gpios:
     maxItems: 1
 
@@ -63,31 +58,17 @@ patternProperties:
           since the chip has a single global setting.
           The maximum output current of each LED is calculated by the
           following formula:
-            IMAXled = 160000 * (592 / 600.5) * (1 / display-rows)
+            IMAXled = 160000 * (592 / 600.5) * (1 / max-current-switch-number)
           And the minimum output current formula:
-            IMINled = 3300 * (592 / 600.5) * (1 / display-rows)
+            IMINled = 3300 * (592 / 600.5) * (1 / max-current-switch-number)
+          where max-current-switch-number is determinated by led configuration
+          and depends on how leds are physically connected to the led driver.
 
 required:
   - compatible
   - reg
   - "#address-cells"
   - "#size-cells"
-  - awinic,display-rows
-
-allOf:
-  - if:
-      properties:
-        compatible:
-          contains:
-            const: awinic,aw20036
-    then:
-      properties:
-        awinic,display-rows:
-          enum: [1, 2, 3]
-    else:
-      properties:
-        awinic,display-rows:
-          enum: [1, 2, 3, 4, 5, 6, 7]
 
 additionalProperties: false
 
@@ -105,7 +86,6 @@ examples:
             reg = <0x3a>;
             #address-cells = <1>;
             #size-cells = <0>;
-            awinic,display-rows = <3>;
             enable-gpios = <&gpio 3 GPIO_ACTIVE_HIGH>;
 
             led@0 {