dmaengine: stm32-dma: fix burst in case of unaligned memory address

Theorically, address pointers used by STM32 DMA must be chosen so as to
ensure that all transfers within a burst block are aligned on the address
boundary equal to the size of the transfer.
If this is always the case for peripheral addresses on STM32, it is not for
memory addresses if the user doesn't respect this alignment constraint.
To avoid a weird behavior of the DMA controller in this case (no error
triggered but data are not transferred as expected), force no burst.
Signed-off-by: Amelie Delaunay <amelie.delaunay@foss.st.com>
Link: https://lore.kernel.org/r/20211011094259.315023-4-amelie.delaunay@foss.st.comSigned-off-by: Vinod Koul <vkoul@kernel.org>

drivers/dma/stm32-dma.c

@@ -753,7 +753,13 @@ static int stm32_dma_set_xfer_param(struct stm32_dma_chan *chan,
 		if (src_bus_width < 0)
 			return src_bus_width;
 
-		/* Set memory burst size */
+		/*
+		 * Set memory burst size - burst not possible if address is not aligned on
+		 * the address boundary equal to the size of the transfer
+		 */
+		if (buf_addr % buf_len)
+			src_maxburst = 1;
+		else
 			src_maxburst = STM32_DMA_MAX_BURST;
 		src_best_burst = stm32_dma_get_best_burst(buf_len,
 							  src_maxburst,
@@ -803,7 +809,13 @@ static int stm32_dma_set_xfer_param(struct stm32_dma_chan *chan,
 		if (dst_bus_width < 0)
 			return dst_bus_width;
 
-		/* Set memory burst size */
+		/*
+		 * Set memory burst size - burst not possible if address is not aligned on
+		 * the address boundary equal to the size of the transfer
+		 */
+		if (buf_addr % buf_len)
+			dst_maxburst = 1;
+		else
 			dst_maxburst = STM32_DMA_MAX_BURST;
 		dst_best_burst = stm32_dma_get_best_burst(buf_len,
 							  dst_maxburst,