Commit b07afe07 authored by David S. Miller's avatar David S. Miller

Merge branch 'mvneta_qsgmii'

Thomas Petazzoni says:

====================
net: mvneta: fix usage as a module, and support QSGMII properly

This set of patches is a new attempt at fixing the operation of the
mvneta driver when built as a module. For the record, the previous
attempt, merged in commit e3a8786c
('net: mvneta: fix usage as a module on RGMII configurations') caused
problems for all RGMII configurations.

In fact, it turned out that the MAC to PHY connection on the Armada XP
GP, which was described as using RGMII-ID according to its Device
Tree, is in fact a QSGMII connection. And the RGMII and QSGMII
configurations have to be handled in a different way in the driver,
because the SERDES configuration is different in those two cases.

So, this patch series fixes that by:

 * Adding minimal handling of a "qsgmii" connection type in the PHY
   layer. Mainly to make sure that a "qsgmii" phy-mode in the Device
   Tree is recognized, and handed over to the driver as
   PHY_INTERFACE_QSGMII.

 * Changing the mvneta driver to properly configure the RGMIIEn and
   PCSEn bits in the GMAC_CTRL_2 register, and configure the SERDES
   register, in the three possible cases: RGMII, SGMII and QSGMII.

 * Updating the Device Tree of the Armada XP GP board to reflect the
   fact that it uses a QSGMII MAC/PHY connection.

PATCH 1 and 2 would be merged by David Miller, through the net tree,
while PATCH 3 would be merged by the mach-mvebu maintainers, through
their tree and arm-soc.

This set of patches has been tested on:

 * Armada XP GP (four QSGMII interfaces)
 * Armada XP DB (two RGMII interfaces and two SGMII interfaces)
 * Armada 370 Mirabox (two RGMII interfaces)

I've tested both the driver built-in, and compiled as a module.

Since the last attempt at fixing this was quite a fiasco, I'd like
this new attempt to be tested more widely before being applied. I'll
try to do some testing on other Armada boards I have, but independent
testing from other persons would also be appreciated.

Note that these patches apply after reverting the previous attempt,
obviously.
====================
Tested-by: default avatarArnaud Ebalard <arno@natisbad.org>
Tested-by: default avatarWilly Tarreau <w@1wt.eu>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parents e283546c 3f1dd4bc
...@@ -10,7 +10,7 @@ The following properties are common to the Ethernet controllers: ...@@ -10,7 +10,7 @@ The following properties are common to the Ethernet controllers:
- max-frame-size: number, maximum transfer unit (IEEE defined MTU), rather than - max-frame-size: number, maximum transfer unit (IEEE defined MTU), rather than
the maximum frame size (there's contradiction in ePAPR). the maximum frame size (there's contradiction in ePAPR).
- phy-mode: string, operation mode of the PHY interface; supported values are - phy-mode: string, operation mode of the PHY interface; supported values are
"mii", "gmii", "sgmii", "tbi", "rev-mii", "rmii", "rgmii", "rgmii-id", "mii", "gmii", "sgmii", "qsgmii", "tbi", "rev-mii", "rmii", "rgmii", "rgmii-id",
"rgmii-rxid", "rgmii-txid", "rtbi", "smii", "xgmii"; this is now a de-facto "rgmii-rxid", "rgmii-txid", "rtbi", "smii", "xgmii"; this is now a de-facto
standard property; standard property;
- phy-connection-type: the same as "phy-mode" property but described in ePAPR; - phy-connection-type: the same as "phy-mode" property but described in ePAPR;
......
...@@ -89,8 +89,9 @@ ...@@ -89,8 +89,9 @@
#define MVNETA_TX_IN_PRGRS BIT(1) #define MVNETA_TX_IN_PRGRS BIT(1)
#define MVNETA_TX_FIFO_EMPTY BIT(8) #define MVNETA_TX_FIFO_EMPTY BIT(8)
#define MVNETA_RX_MIN_FRAME_SIZE 0x247c #define MVNETA_RX_MIN_FRAME_SIZE 0x247c
#define MVNETA_SGMII_SERDES_CFG 0x24A0 #define MVNETA_SERDES_CFG 0x24A0
#define MVNETA_SGMII_SERDES_PROTO 0x0cc7 #define MVNETA_SGMII_SERDES_PROTO 0x0cc7
#define MVNETA_QSGMII_SERDES_PROTO 0x0667
#define MVNETA_TYPE_PRIO 0x24bc #define MVNETA_TYPE_PRIO 0x24bc
#define MVNETA_FORCE_UNI BIT(21) #define MVNETA_FORCE_UNI BIT(21)
#define MVNETA_TXQ_CMD_1 0x24e4 #define MVNETA_TXQ_CMD_1 0x24e4
...@@ -711,35 +712,6 @@ static void mvneta_rxq_bm_disable(struct mvneta_port *pp, ...@@ -711,35 +712,6 @@ static void mvneta_rxq_bm_disable(struct mvneta_port *pp,
mvreg_write(pp, MVNETA_RXQ_CONFIG_REG(rxq->id), val); mvreg_write(pp, MVNETA_RXQ_CONFIG_REG(rxq->id), val);
} }
/* Sets the RGMII Enable bit (RGMIIEn) in port MAC control register */
static void mvneta_gmac_rgmii_set(struct mvneta_port *pp, int enable)
{
u32 val;
val = mvreg_read(pp, MVNETA_GMAC_CTRL_2);
if (enable)
val |= MVNETA_GMAC2_PORT_RGMII;
else
val &= ~MVNETA_GMAC2_PORT_RGMII;
mvreg_write(pp, MVNETA_GMAC_CTRL_2, val);
}
/* Config SGMII port */
static void mvneta_port_sgmii_config(struct mvneta_port *pp)
{
u32 val;
val = mvreg_read(pp, MVNETA_GMAC_CTRL_2);
val |= MVNETA_GMAC2_PCS_ENABLE;
mvreg_write(pp, MVNETA_GMAC_CTRL_2, val);
mvreg_write(pp, MVNETA_SGMII_SERDES_CFG, MVNETA_SGMII_SERDES_PROTO);
}
/* Start the Ethernet port RX and TX activity */ /* Start the Ethernet port RX and TX activity */
static void mvneta_port_up(struct mvneta_port *pp) static void mvneta_port_up(struct mvneta_port *pp)
{ {
...@@ -2749,26 +2721,44 @@ static void mvneta_conf_mbus_windows(struct mvneta_port *pp, ...@@ -2749,26 +2721,44 @@ static void mvneta_conf_mbus_windows(struct mvneta_port *pp,
} }
/* Power up the port */ /* Power up the port */
static void mvneta_port_power_up(struct mvneta_port *pp, int phy_mode) static int mvneta_port_power_up(struct mvneta_port *pp, int phy_mode)
{ {
u32 val; u32 ctrl;
/* MAC Cause register should be cleared */ /* MAC Cause register should be cleared */
mvreg_write(pp, MVNETA_UNIT_INTR_CAUSE, 0); mvreg_write(pp, MVNETA_UNIT_INTR_CAUSE, 0);
if (phy_mode == PHY_INTERFACE_MODE_SGMII) ctrl = mvreg_read(pp, MVNETA_GMAC_CTRL_2);
mvneta_port_sgmii_config(pp);
mvneta_gmac_rgmii_set(pp, 1); /* Even though it might look weird, when we're configured in
* SGMII or QSGMII mode, the RGMII bit needs to be set.
*/
switch(phy_mode) {
case PHY_INTERFACE_MODE_QSGMII:
mvreg_write(pp, MVNETA_SERDES_CFG, MVNETA_QSGMII_SERDES_PROTO);
ctrl |= MVNETA_GMAC2_PCS_ENABLE | MVNETA_GMAC2_PORT_RGMII;
break;
case PHY_INTERFACE_MODE_SGMII:
mvreg_write(pp, MVNETA_SERDES_CFG, MVNETA_SGMII_SERDES_PROTO);
ctrl |= MVNETA_GMAC2_PCS_ENABLE | MVNETA_GMAC2_PORT_RGMII;
break;
case PHY_INTERFACE_MODE_RGMII:
case PHY_INTERFACE_MODE_RGMII_ID:
ctrl |= MVNETA_GMAC2_PORT_RGMII;
break;
default:
return -EINVAL;
}
/* Cancel Port Reset */ /* Cancel Port Reset */
val = mvreg_read(pp, MVNETA_GMAC_CTRL_2); ctrl &= ~MVNETA_GMAC2_PORT_RESET;
val &= ~MVNETA_GMAC2_PORT_RESET; mvreg_write(pp, MVNETA_GMAC_CTRL_2, ctrl);
mvreg_write(pp, MVNETA_GMAC_CTRL_2, val);
while ((mvreg_read(pp, MVNETA_GMAC_CTRL_2) & while ((mvreg_read(pp, MVNETA_GMAC_CTRL_2) &
MVNETA_GMAC2_PORT_RESET) != 0) MVNETA_GMAC2_PORT_RESET) != 0)
continue; continue;
return 0;
} }
/* Device initialization routine */ /* Device initialization routine */
...@@ -2879,7 +2869,12 @@ static int mvneta_probe(struct platform_device *pdev) ...@@ -2879,7 +2869,12 @@ static int mvneta_probe(struct platform_device *pdev)
dev_err(&pdev->dev, "can't init eth hal\n"); dev_err(&pdev->dev, "can't init eth hal\n");
goto err_free_stats; goto err_free_stats;
} }
mvneta_port_power_up(pp, phy_mode);
err = mvneta_port_power_up(pp, phy_mode);
if (err < 0) {
dev_err(&pdev->dev, "can't power up port\n");
goto err_deinit;
}
dram_target_info = mv_mbus_dram_info(); dram_target_info = mv_mbus_dram_info();
if (dram_target_info) if (dram_target_info)
......
...@@ -75,6 +75,7 @@ typedef enum { ...@@ -75,6 +75,7 @@ typedef enum {
PHY_INTERFACE_MODE_SMII, PHY_INTERFACE_MODE_SMII,
PHY_INTERFACE_MODE_XGMII, PHY_INTERFACE_MODE_XGMII,
PHY_INTERFACE_MODE_MOCA, PHY_INTERFACE_MODE_MOCA,
PHY_INTERFACE_MODE_QSGMII,
PHY_INTERFACE_MODE_MAX, PHY_INTERFACE_MODE_MAX,
} phy_interface_t; } phy_interface_t;
...@@ -116,6 +117,8 @@ static inline const char *phy_modes(phy_interface_t interface) ...@@ -116,6 +117,8 @@ static inline const char *phy_modes(phy_interface_t interface)
return "xgmii"; return "xgmii";
case PHY_INTERFACE_MODE_MOCA: case PHY_INTERFACE_MODE_MOCA:
return "moca"; return "moca";
case PHY_INTERFACE_MODE_QSGMII:
return "qsgmii";
default: default:
return "unknown"; return "unknown";
} }
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment