gpio: pca953x: Fix pca953x_gpio_set_pull_up_down()

A previous fix, commit dc87f6dd ("gpio: pca953x: Fix
pca953x_gpio_set_config"), identified that pinconf_to_config_param() needed
to be used to isolate the config_param from the pinconf in
pca953x_gpio_set_config(). This fix however did not consider that this
would also be needed in pca953x_gpio_set_pull_up_down() to which it passes
this config.

Perform a similar call in pca953x_gpio_set_pull_up_down() to isolate the
configuration parameter there as well, rather than passing it from
pca953x_gpio_set_config() as the configuration argument may also be needed
in pca953x_gpio_set_pull_up_down() at a later date.
Signed-off-by: Martyn Welch <martyn.welch@collabora.com>
Acked-by: Linus Walleij <linus.walleij@linaro.org>
Reviewed-by: Andy Shevchenko <andy.shevchenko@gmail.com>
Signed-off-by: Bartosz Golaszewski <brgl@bgdev.pl>

drivers/gpio/gpio-pca953x.c

@@ -549,6 +549,8 @@ static int pca953x_gpio_set_pull_up_down(struct pca953x_chip *chip,
 					 unsigned int offset,
 					 unsigned long config)
 {
+	enum pin_config_param param = pinconf_to_config_param(config);
+
 	u8 pull_en_reg = pca953x_recalc_addr(chip, PCAL953X_PULL_EN, offset);
 	u8 pull_sel_reg = pca953x_recalc_addr(chip, PCAL953X_PULL_SEL, offset);
 	u8 bit = BIT(offset % BANK_SZ);
@@ -564,9 +566,9 @@ static int pca953x_gpio_set_pull_up_down(struct pca953x_chip *chip,
 	mutex_lock(&chip->i2c_lock);
 
 	/* Configure pull-up/pull-down */
-	if (config == PIN_CONFIG_BIAS_PULL_UP)
+	if (param == PIN_CONFIG_BIAS_PULL_UP)
 		ret = regmap_write_bits(chip->regmap, pull_sel_reg, bit, bit);
-	else if (config == PIN_CONFIG_BIAS_PULL_DOWN)
+	else if (param == PIN_CONFIG_BIAS_PULL_DOWN)
 		ret = regmap_write_bits(chip->regmap, pull_sel_reg, bit, 0);
 	else
 		ret = 0;
@@ -574,7 +576,7 @@ static int pca953x_gpio_set_pull_up_down(struct pca953x_chip *chip,
 		goto exit;
 
 	/* Disable/Enable pull-up/pull-down */
-	if (config == PIN_CONFIG_BIAS_DISABLE)
+	if (param == PIN_CONFIG_BIAS_DISABLE)
 		ret = regmap_write_bits(chip->regmap, pull_en_reg, bit, 0);
 	else
 		ret = regmap_write_bits(chip->regmap, pull_en_reg, bit, bit);