mtd: rawnand: initialize ntargets with maxchips

memorg->ntargets is initialized with '1'. It should be initialized with
the maxchips argument from nand_scan() instead. Otherwise multi chip
support errors out on the secondary chip selects when trying to call
nand_reset() on them:

WARNING: CPU: 0 PID: 1 at drivers/mtd/nand/raw/internals.h:114
nand_reset_op+0x194/0x1c4

With this memorg->ntargets is initialized with the maximum number of
chip selects supported by the driver. After having detected the number
of actually connected chips memory->ntargets is updated with that
number.

Fixes: 32813e28 ("mtd: rawnand: Get rid of chip->numchips")
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
Reviewed-by: Boris Brezillon <boris.brezillon@collabora.com>
Signed-off-by: Miquel Raynal <miquel.raynal@bootlin.com>

drivers/mtd/nand/raw/nand_base.c

@@ -4666,7 +4666,6 @@ static int nand_detect(struct nand_chip *chip, struct nand_flash_dev *type)
 	memorg = nanddev_get_memorg(&chip->base);
 	memorg->planes_per_lun = 1;
 	memorg->luns_per_target = 1;
-	memorg->ntargets = 1;
 
 	/*
 	 * Reset the chip, required by some chips (e.g. Micron MT29FxGxxxxx)
@@ -5031,6 +5030,8 @@ static int nand_scan_ident(struct nand_chip *chip, unsigned int maxchips,
 	if (ret)
 		return ret;
 
+	memorg->ntargets = maxchips;
+
 	/* Read the flash type */
 	ret = nand_detect(chip, table);
 	if (ret) {