Commit b5a63788 authored by Kalle Valo's avatar Kalle Valo

ath6kl: update Kconfig descriptions

The help text were either out of date, too small or didn't exist at all. Also
move cfg80211 dependency to ath6kl_core module as it has all the calls to
cfg80211.

Fixes checkpatch warning:

WARNING: please write a paragraph that describes the config symbol fully
Signed-off-by: default avatarKalle Valo <kvalo@qca.qualcomm.com>
parent 996bc932
config ATH6KL
tristate "Atheros mobile chipsets support"
depends on CFG80211
---help---
This module adds core support for wireless adapters based on
Atheros AR6003 and AR6004 chipsets. You still need separate
bus drivers for USB and SDIO to be able to use real devices.
If you choose to build it as a module, it will be called
ath6kl_core. Please note that AR6002 and AR6001 are not
supported by this driver.
config ATH6KL_SDIO
tristate "Atheros ath6kl SDIO support"
depends on ATH6KL
depends on MMC
depends on CFG80211
---help---
This module adds support for wireless adapters based on
Atheros AR6003 and AR6004 chipsets running over SDIO. If you
......@@ -17,25 +25,31 @@ config ATH6KL_USB
tristate "Atheros ath6kl USB support"
depends on ATH6KL
depends on USB
depends on CFG80211
---help---
This module adds support for wireless adapters based on
Atheros AR6004 chipset running over USB. This is still under
implementation and it isn't functional. If you choose to
build it as a module, it will be called ath6kl_usb.
Atheros AR6004 chipset and chipsets based on it running over
USB. If you choose to build it as a module, it will be
called ath6kl_usb.
config ATH6KL_DEBUG
bool "Atheros ath6kl debugging"
depends on ATH6KL
---help---
Enables debug support
Enables ath6kl debug support, including debug messages
enabled with debug_mask module parameter and debugfs
interface.
If unsure, say Y to make it easier to debug problems.
config ATH6KL_TRACING
bool "Atheros ath6kl tracing support"
depends on ATH6KL
depends on EVENT_TRACING
---help---
Select this to ath6kl use tracing infrastructure.
Select this to ath6kl use tracing infrastructure which, for
example, can be enabled with help of trace-cmd. All debug
messages and commands are delivered to using individually
enablable trace points.
If unsure, say Y to make it easier to debug problems.
......@@ -47,3 +61,5 @@ config ATH6KL_REGDOMAIN
Enabling this makes it possible to change the regdomain in
the firmware. This can be only enabled if regulatory requirements
are taken into account.
If unsure, say N.
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment