ethernet: lpc: use eth_hw_addr_set()

Commit 406f42fa ("net-next: When a bond have a massive amount
of VLANs...") introduced a rbtree for faster Ethernet address look
up. To maintain netdev->dev_addr in this tree we need to make all
the writes to it got through appropriate helpers.

Read the address into an array on the stack, then call
eth_hw_addr_set().
Signed-off-by: Jakub Kicinski <kuba@kernel.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/nxp/lpc_eth.c

@@ -1232,6 +1232,7 @@ static int lpc_eth_drv_probe(struct platform_device *pdev)
 	struct net_device *ndev;
 	dma_addr_t dma_handle;
 	struct resource *res;
+	u8 addr[ETH_ALEN];
 	int irq, ret;
 
 	/* Setup network interface for RMII or MII mode */
@@ -1347,7 +1348,8 @@ static int lpc_eth_drv_probe(struct platform_device *pdev)
 	pldat->phy_node = of_parse_phandle(np, "phy-handle", 0);
 
 	/* Get MAC address from current HW setting (POR state is all zeros) */
-	__lpc_get_mac(pldat, ndev->dev_addr);
+	__lpc_get_mac(pldat, addr);
+	eth_hw_addr_set(ndev, addr);
 
 	if (!is_valid_ether_addr(ndev->dev_addr)) {
 		of_get_ethdev_address(np, ndev);