ARM: dts: qcom: Correct USB3503 GPIOs polarity

Current USB3503 driver ignores GPIO polarity and always operates as if the
GPIO lines were flagged as ACTIVE_HIGH. Fix the polarity for the existing
USB3503 chip applications to match the chip specification and common
convention for naming the pins. The only pin, which has to be ACTIVE_LOW
is the reset pin. The remaining are ACTIVE_HIGH. This change allows later
to fix the USB3503 driver to properly use generic GPIO bindings and read
polarity from DT.
Signed-off-by: Marek Szyprowski <m.szyprowski@samsung.com>
Reviewed-by: Linus Walleij <linus.walleij@linaro.org>
Acked-by: Bjorn Andersson <bjorn.andersson@linaro.org>
Link: https://lore.kernel.org/r/20191211145208.24976-1-m.szyprowski@samsung.comSigned-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

arch/arm/boot/dts/qcom-mdm9615-wp8548-mangoh-green.dts

@@ -143,7 +143,7 @@ usbhub: hub@8 {
 				compatible = "smsc,usb3503a";
 				reg = <0x8>;
 				connect-gpios = <&gpioext2 1 GPIO_ACTIVE_HIGH>;
-				intn-gpios = <&gpioext2 0 GPIO_ACTIVE_LOW>;
+				intn-gpios = <&gpioext2 0 GPIO_ACTIVE_HIGH>;
 				initial-mode = <1>;
 			};
 		};