Commit cca28a5f authored by Linus Torvalds's avatar Linus Torvalds

Merge tag 'for-linus-20150310' of git://git.infradead.org/linux-mtd

Pull MTD fixes from Brian Norris:

 * pxa3xx_nand
   - fix timeout issues when draining the FIFO (BCH only)
   - don't crash when no chip-selects are used

 * hisi504_nand
   - depend on HAS_DMA, to fix compile errors

* tag 'for-linus-20150310' of git://git.infradead.org/linux-mtd:
  mtd: nand: MTD_NAND_HISI504 should depend on HAS_DMA
  mtd: pxa3xx_nand: fix driver when num_cs is 0
  mtd: nand: pxa3xx: Fix PIO FIFO draining
parents 9c3e1323 5e0899db
......@@ -526,6 +526,7 @@ config MTD_NAND_SUNXI
config MTD_NAND_HISI504
tristate "Support for NAND controller on Hisilicon SoC Hip04"
depends on HAS_DMA
help
Enables support for NAND controller on Hisilicon SoC Hip04.
......
......@@ -480,6 +480,42 @@ static void disable_int(struct pxa3xx_nand_info *info, uint32_t int_mask)
nand_writel(info, NDCR, ndcr | int_mask);
}
static void drain_fifo(struct pxa3xx_nand_info *info, void *data, int len)
{
if (info->ecc_bch) {
int timeout;
/*
* According to the datasheet, when reading from NDDB
* with BCH enabled, after each 32 bytes reads, we
* have to make sure that the NDSR.RDDREQ bit is set.
*
* Drain the FIFO 8 32 bits reads at a time, and skip
* the polling on the last read.
*/
while (len > 8) {
__raw_readsl(info->mmio_base + NDDB, data, 8);
for (timeout = 0;
!(nand_readl(info, NDSR) & NDSR_RDDREQ);
timeout++) {
if (timeout >= 5) {
dev_err(&info->pdev->dev,
"Timeout on RDDREQ while draining the FIFO\n");
return;
}
mdelay(1);
}
data += 32;
len -= 8;
}
}
__raw_readsl(info->mmio_base + NDDB, data, len);
}
static void handle_data_pio(struct pxa3xx_nand_info *info)
{
unsigned int do_bytes = min(info->data_size, info->chunk_size);
......@@ -496,12 +532,12 @@ static void handle_data_pio(struct pxa3xx_nand_info *info)
DIV_ROUND_UP(info->oob_size, 4));
break;
case STATE_PIO_READING:
__raw_readsl(info->mmio_base + NDDB,
drain_fifo(info,
info->data_buff + info->data_buff_pos,
DIV_ROUND_UP(do_bytes, 4));
if (info->oob_size > 0)
__raw_readsl(info->mmio_base + NDDB,
drain_fifo(info,
info->oob_buff + info->oob_buff_pos,
DIV_ROUND_UP(info->oob_size, 4));
break;
......@@ -1572,6 +1608,8 @@ static int alloc_nand_resource(struct platform_device *pdev)
int ret, irq, cs;
pdata = dev_get_platdata(&pdev->dev);
if (pdata->num_cs <= 0)
return -ENODEV;
info = devm_kzalloc(&pdev->dev, sizeof(*info) + (sizeof(*mtd) +
sizeof(*host)) * pdata->num_cs, GFP_KERNEL);
if (!info)
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment