Commit cce483e0 authored by Daniel Lezcano's avatar Daniel Lezcano

clocksource/drivers/h8300_timer8: Retrieve the clock rate at init time

The current code retrieves the rate value when the timer is enabled which
occurs each time a timer is re-armed. Except if the clock frequency has changed
magically I don't see why this should be done each time.

Retrieve the clock rate value at init time only.
Signed-off-by: default avatarDaniel Lezcano <daniel.lezcano@linaro.org>
parent 254d8b5d
......@@ -34,7 +34,6 @@ struct timer8_priv {
unsigned long flags;
unsigned int rate;
unsigned int tcora;
struct clk *pclk;
};
static unsigned long timer8_get_counter(struct timer8_priv *p)
......@@ -92,7 +91,6 @@ static void timer8_set_next(struct timer8_priv *p, unsigned long delta)
static int timer8_enable(struct timer8_priv *p)
{
p->rate = clk_get_rate(p->pclk) / SCALE;
ctrl_outw(0xffff, p->mapbase + TCORA);
ctrl_outw(0x0000, p->mapbase + _8TCNT);
ctrl_outw(0x0c02, p->mapbase + _8TCR);
......@@ -102,16 +100,15 @@ static int timer8_enable(struct timer8_priv *p)
static int timer8_start(struct timer8_priv *p)
{
int ret = 0;
int ret;
if (!(p->flags & FLAG_STARTED))
ret = timer8_enable(p);
if ((p->flags & FLAG_STARTED))
return 0;
if (ret)
goto out;
ret = timer8_enable(p);
if (!ret)
p->flags |= FLAG_STARTED;
out:
return ret;
}
......@@ -217,7 +214,12 @@ static void __init h8300_8timer_init(struct device_node *node)
}
timer8_priv.mapbase = (unsigned long)base;
timer8_priv.pclk = clk;
rate = clk_get_rate(clk) / SCALE;
if (!rate) {
pr_err("Failed to get rate for the clocksource\n");
goto unmap_reg;
}
ret = request_irq(irq, timer8_interrupt,
IRQF_TIMER, timer8_priv.ced.name, &timer8_priv);
......@@ -225,10 +227,10 @@ static void __init h8300_8timer_init(struct device_node *node)
pr_err("failed to request irq %d for clockevent\n", irq);
goto unmap_reg;
}
rate = clk_get_rate(clk) / SCALE;
clockevents_config_and_register(&timer8_priv.ced, rate, 1, 0x0000ffff);
return;
return;
unmap_reg:
iounmap(base);
free_clk:
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment