ACPI, x86: Use SRAT table rev to use 8bit or 32bit PXM fields (x86/x86-64)

In SRAT v1, we had 8bit proximity domain (PXM) fields; SRAT v2 provides
32bits for these. The new fields were reserved before.
According to the ACPI spec, the OS must disregrard reserved fields.

x86/x86-64 was rather inconsistent prior to this patch; it used 8 bits
for the pxm field in cpu_affinity, but 32 bits in mem_affinity.
This patch makes it consistent: Either use 8 bits consistently (SRAT
rev 1 or lower) or 32 bits (SRAT rev 2 or higher).

cc: x86@kernel.org
Signed-off-by: Kurt Garloff <kurt@garloff.de>
Signed-off-by: Len Brown <len.brown@intel.com>

arch/x86/mm/srat.c

@@ -104,6 +104,8 @@ acpi_numa_processor_affinity_init(struct acpi_srat_cpu_affinity *pa)
 	if ((pa->flags & ACPI_SRAT_CPU_ENABLED) == 0)
 		return;
 	pxm = pa->proximity_domain_lo;
+	if (acpi_srat_revision >= 2)
+		pxm |= *((unsigned int*)pa->proximity_domain_hi) << 8;
 	node = setup_node(pxm);
 	if (node < 0) {
 		printk(KERN_ERR "SRAT: Too many proximity domains %x\n", pxm);
@@ -155,6 +157,8 @@ acpi_numa_memory_affinity_init(struct acpi_srat_mem_affinity *ma)
 	start = ma->base_address;
 	end = start + ma->length;
 	pxm = ma->proximity_domain;
+	if (acpi_srat_revision <= 1)
+		pxm &= 0xff;
 	node = setup_node(pxm);
 	if (node < 0) {
 		printk(KERN_ERR "SRAT: Too many proximity domains.\n");