arm64: dts: qcom: Switch sc7180-trogdor to control SPI CS via GPIO

As talked about in the patch ("arm64: dts: qcom: sc7180: Provide
pinconf for SPI to use GPIO for CS"), on some boards it makes much
more sense (and is much more efficient) to think of the SPI Chip
Select as a GPIO.  Trogdor is one such board where the SPI parts don't
run in GSI mode and we do a lot of SPI traffic.
Signed-off-by: Douglas Anderson <dianders@chromium.org>
Reviewed-by: Stephen Boyd <swboyd@chromium.org>
Reviewed-by: Akash Asthana <akashast@codeaurora.org>
Link: https://lore.kernel.org/r/20200921142655.v3.2.I3c57d8b6d83d5bdad73a413eea1e249a98d11973@changeidSigned-off-by: Bjorn Andersson <bjorn.andersson@linaro.org>

arch/arm64/boot/dts/qcom/sc7180-trogdor.dtsi

@@ -776,7 +776,20 @@ &sdhc_2 {
 	cd-gpios = <&tlmm 69 GPIO_ACTIVE_LOW>;
 };
 
+&spi0 {
+	pinctrl-0 = <&qup_spi0_cs_gpio>;
+	cs-gpios = <&tlmm 37 GPIO_ACTIVE_LOW>;
+};
+
+&spi6 {
+	pinctrl-0 = <&qup_spi6_cs_gpio>;
+	cs-gpios = <&tlmm 62 GPIO_ACTIVE_LOW>;
+};
+
 ap_spi_fp: &spi10 {
+	pinctrl-0 = <&qup_spi10_cs_gpio>;
+	cs-gpios = <&tlmm 89 GPIO_ACTIVE_LOW>;
+
 	cros_ec_fp: ec@0 {
 		compatible = "google,cros-ec-spi";
 		reg = <0>;
@@ -937,7 +950,7 @@ pinconf {
 	};
 };
 
-&qup_spi0_default {
+&qup_spi0_cs_gpio {
 	pinconf {
 		pins = "gpio34", "gpio35", "gpio36", "gpio37";
 		drive-strength = <2>;
@@ -945,7 +958,7 @@ pinconf {
 	};
 };
 
-&qup_spi6_default {
+&qup_spi6_cs_gpio {
 	pinconf {
 		pins = "gpio59", "gpio60", "gpio61", "gpio62";
 		drive-strength = <2>;
@@ -953,7 +966,7 @@ pinconf {
 	};
 };
 
-&qup_spi10_default {
+&qup_spi10_cs_gpio {
 	pinconf {
 		pins = "gpio86", "gpio87", "gpio88", "gpio89";
 		drive-strength = <2>;