Commit d47d1d27 authored by Stefan Hajnoczi's avatar Stefan Hajnoczi Committed by Dan Williams

pmem: return EIO on read_pmem() failure

The read_pmem() function uses memcpy_mcsafe() on x86 where an EFAULT
error code indicates a failed read.  Block I/O should use EIO to
indicate failure.  Other pmem code paths (like bad blocks) already use
EIO so let's be consistent.

This fixes compatibility with consumers like btrfs that try to parse the
specific error code rather than treat all errors the same.
Reviewed-by: default avatarJeff Moyer <jmoyer@redhat.com>
Signed-off-by: default avatarStefan Hajnoczi <stefanha@redhat.com>
Signed-off-by: default avatarDan Williams <dan.j.williams@intel.com>
parent a121103c
...@@ -90,7 +90,9 @@ static int read_pmem(struct page *page, unsigned int off, ...@@ -90,7 +90,9 @@ static int read_pmem(struct page *page, unsigned int off,
rc = memcpy_from_pmem(mem + off, pmem_addr, len); rc = memcpy_from_pmem(mem + off, pmem_addr, len);
kunmap_atomic(mem); kunmap_atomic(mem);
return rc; if (rc)
return -EIO;
return 0;
} }
static int pmem_do_bvec(struct pmem_device *pmem, struct page *page, static int pmem_do_bvec(struct pmem_device *pmem, struct page *page,
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment