ixgbe: Remove second instance of lan_id variable

This patch removes the redundant lan_id in the phy struct and uses
the bus version.  Both variables exist and intend to represent the
STATUS register LAN_ID field.  However, phy.lan_id is not bit shifted
so the phy.lan_id = 0x0 for LAN Id 0 and phy.lan_id = 0x4 for LAN Id 1.
Where bus.lan_id is bit shifted so bus.lan_id = 0x0 for LAN Id 0 and
bus.lan_id = 0x1 for LAN Id 1. There seems no need for the additional
lan_id variable and this should make the code less confusing.
Signed-off-by: Donald C Skidmore <donald.c.skidmore@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>

drivers/net/ethernet/intel/ixgbe/ixgbe_phy.c

@@ -243,9 +243,7 @@ s32 ixgbe_identify_phy_generic(struct ixgbe_hw *hw)
 	u16 ext_ability = 0;
 
 	if (!hw->phy.phy_semaphore_mask) {
-		hw->phy.lan_id = IXGBE_READ_REG(hw, IXGBE_STATUS) &
-				 IXGBE_STATUS_LAN_ID_1;
-		if (hw->phy.lan_id)
+		if (hw->bus.lan_id)
 			hw->phy.phy_semaphore_mask = IXGBE_GSSR_PHY1_SM;
 		else
 			hw->phy.phy_semaphore_mask = IXGBE_GSSR_PHY0_SM;

drivers/net/ethernet/intel/ixgbe/ixgbe_type.h

@@ -3381,7 +3381,6 @@ struct ixgbe_phy_info {
 	bool                            sfp_setup_needed;
 	u32                             revision;
 	enum ixgbe_media_type           media_type;
-	u8				lan_id;
 	u32				phy_semaphore_mask;
 	bool                            reset_disable;
 	ixgbe_autoneg_advertised        autoneg_advertised;