[media] ARM: DT: STi: STiH407: Add c8sectpfe LinuxDVB DT node

This patch adds in the required DT node for the c8sectpfe
Linux DVB demux driver which allows the tsin channels
to be used on an upstream kernel.
Signed-off-by: Peter Griffin <peter.griffin@linaro.org>
Acked-by: Lee Jones <lee.jones@linaro.org>
Signed-off-by: Mauro Carvalho Chehab <mchehab@osg.samsung.com>

arch/arm/boot/dts/stihxxx-b2120.dtsi

@@ -6,6 +6,9 @@
  * it under the terms of the GNU General Public License version 2 as
  * published by the Free Software Foundation.
  */
+
+#include <dt-bindings/clock/stih407-clks.h>
+#include <dt-bindings/media/c8sectpfe.h>
 / {
 	soc {
 		sbc_serial0: serial@9530000 {
@@ -99,5 +102,38 @@ ethernet0: dwmac@9630000 {
 			phy-mode = "rgmii";
 			fixed-link = <0 1 1000 0 0>;
 		};
+
+		demux@08a20000 {
+			compatible	= "st,stih407-c8sectpfe";
+			status		= "okay";
+			reg		= <0x08a20000 0x10000>,
+					  <0x08a00000 0x4000>;
+			reg-names	= "c8sectpfe", "c8sectpfe-ram";
+			interrupts	= <GIC_SPI 34 IRQ_TYPE_NONE>,
+					  <GIC_SPI 35 IRQ_TYPE_NONE>;
+			interrupt-names	= "c8sectpfe-error-irq",
+					  "c8sectpfe-idle-irq";
+			pinctrl-0	= <&pinctrl_tsin0_serial>;
+			pinctrl-1	= <&pinctrl_tsin0_parallel>;
+			pinctrl-2	= <&pinctrl_tsin3_serial>;
+			pinctrl-3	= <&pinctrl_tsin4_serial_alt3>;
+			pinctrl-4	= <&pinctrl_tsin5_serial_alt1>;
+			pinctrl-names	= "tsin0-serial",
+					  "tsin0-parallel",
+					  "tsin3-serial",
+					  "tsin4-serial",
+					  "tsin5-serial";
+			clocks		= <&clk_s_c0_flexgen CLK_PROC_STFE>;
+			clock-names	= "c8sectpfe";
+
+			/* tsin0 is TSA on NIMA */
+			tsin0: port@0 {
+				tsin-num	= <0>;
+				serial-not-parallel;
+				i2c-bus		= <&ssc2>;
+				rst-gpio	= <&pio15 4 GPIO_ACTIVE_HIGH>;
+				dvb-card	= <STV0367_TDA18212_NIMA_1>;
+			};
+		};
 	};
 };